Installation Instructions

ManualsBrandsToro ManualsAttachmentsFront Brush/Scraper Kit, Greensmaster 3250-D Cutting Units

Printed in the USA

 2001 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Form No. 3325-943

Installation

Instructions

Part No. 104-7731

Front Brush/Scraper Kit

Greensmaster



3250-D

If you leave the key in the ignition switch, someone

could accidently start the engine and seriously

injure you or other bystanders.

Remove the key from the ignition and disconnect

the wire from the spark plug before you do any

maintenance. Set the wire aside so that it does not

accidentally contact the spark plug.

Caution

1. Loosen the screws securing each end of the roller shaft

to the front roller brackets (Fig. 1).

2. Remove the bolts and locknuts securing the left front

roller bracket to the side plate (Fig. 1).

3. Slide a clamp block onto each end of the roller shaft.

Position the clamp blocks so that the slot is up and the

threaded portion of the hole is rearward (Fig. 1).

4. Thread a nut onto each scraper rod.

5. Insert both scraper rods through the clamp blocks.

Loosely secure the scraper rods to the clamp blocks

with a nut (Fig. 1).

6. Partially thread a socket head screw into the front of

each clamp block (Fig. 1).

7. Install the roller and brush/scraper to the cutting unit

with the front roller bracket and fasteners previously

removed. Position the brush/scraper with the scraper to

the rear of the roller and the brush downward.

8. Level the front roller and set the height-of-cut; refer to

the Cutting Unit Operator’s Manual for adjustment

procedures.

9. Adjust the aggressiveness of the brush as follows:

• For an aggressive setting, adjust the brush assembly

so that the bristles touch the adjusting gauge bar.

• For a medium setting, adjust the brush assembly so

that it is midway between the adjusting gauge bar

and the cutting edge of the bedknife.

• For a light setting, adjust the brush assembly so that

it is even with the cutting edge of the bedknife.

Note: To simplify the procedure, secure one end of the

brush assembly at a time.

10. Tighten the socket head screws securing the clamp

blocks to the roller shaft (Fig. 1).

11. Adjust the nuts on each scraper rod until there is a

clearance of approximately 1/32 in. (8 mm) between the

scraper and the roller. Make sure that the scraper is

parallel to the roller.

Figure 1

1. Front roller bracket (left)

2. Front roller

3. Clamp block

4. Scraper rod

5. Socket head screw