Installation Instructions

1
INSTRUCTION SHEET
FORM NO. 104-9056
FUSE HOLDER INSTRUCTION SHEET FOR
MULTI-PRO
®
1250
©The TORO Company - 2002
All Rights Reserved
INSTALLATION:
1. To install the Fuse older, unplug the Boom
Control Valve from the Spray System Harness at
the rear of the machine.
1. 104-9054 - Fuse Holder w/1 amp Fuse
2. 104-9055 - 1 amp Blade Terminal Fuse
2011
In order to protect the Boom Valve Motors, a
1 amp Fuse is being added to the wire
harness. The part numbers are shown in the
following picture.
3. If the 1 amp Fuse fails, DO NOT install a larger
fuse. If the Fuse fails repeatedly, contact your
Toro Distributor for further instructions.
FIG. 1
FIG. 2
1. Boom Control Valve 2. Spray System Harness
2
1
2012
2013
2. Plug the mating connectors from the Fuse
Holder into the proper connectors on the Wire
Harness and the Boom Control Valve. Install one
Fuse Holder for each of the Three Boom Control
Valves.
1. Fuse Holder 2. Wire Harness
FIG. 3
3. Boom Control Valve
2
1
2
1
3
PART NO. 104-9054