Installation Instructions

1
All Rights Reserved
Printed in the USA
 2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Form No. 3325–939
Installation
Instructions
Part No. 104–9317
Reel Drive Hose Kit
Reelmaster

5200/5400
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Make sure all hydraulic fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
• Keep your body and hands away from pin hole
leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic leaks.
• Get immediate medical help if fluid is injected
into skin.
Warning
1. Locate and remove hoses to be replaced. Refer to
figure 3.
Note: When removing old hoses, remember how they were
routed through components in machine.
2. Insert each set of new hoses (3) into a protective sleeve.
Part number of each new hose is shown in figure.
Note: Shorter protective sleeve is used on hoses for front
center cutting unit.
Front Cutting Units
3. Using dimensions shown in figure 1, position and
secure each end of protective sleeve to front hoses with
a cable tie.
2
1
8.50”
1.50”
Figure 1
1. Protective cover 2. Cable tie
Rear Cutting Units
4. Using dimensions shown in figure 2, position and
secure each end of protective sleeve to rear hoses with a
cable tie.
2
1
12.00”
1.50”
Figure 2
1. Protective cover 2. Cable tie
5. Route each set of hoses and protective sleeve through
appropriate hose guide and secure to reel motor and
traction unit.