Installation Instructions

5. If you are using Greensmaster 3200/3250 cutting units,

adjust the screw and jam nut (Fig. 13) to bring the

cutting unit up to the rubber stop on the carrier frame

while in the transport position. Remove the screw and

jam nut when mounting cutting unit models 04404,

04406, 04408, 04450, 04468, 04610 or 04611.

3/4 in. factory

setting

Figure 13

Right-Hand Cutting Unit Shown

1. Right-hand clevis 2. Screw and jam nut

6. Install the reel motors and right and left wheel shields

(Fig. 2).

7. For Dual Point Adjust (DPA) cutting units only, modify

Greensmaster 3100/3150 grass baskets (not supplied

with kit) as follows:

A. Locate and mark cut–off lines on each side of the

baskets, as shown in figure 14.

Figure 14

1. Cut–off line

B. Using a sharp knife or similar cutting tool, cut off

material at marks.

C. Repeat procedure on all baskets.

8. Mount the grass baskets onto the pull frame assemblies.

9. Grease all fittings with general purpose lithium-based

grease.