Installation Instructions

Printed in the USA

 2001 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Adapter Kit

2002 and Later Snow/Dozer Blade to 2001 and Earlier GT

Classic Garden Tractor

Part No. 105–1501

Form No. 3327–134

Installation Instructions

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Lever 1 Installing the New Lever

Cable 1 Installing the New Cable

Installing the New Lever

1. Disengage the power take off (PTO), set the parking

brake and turn the ignition key to off. Remove the key.

2. Remove the existing index lever from the snow/dozer

blade (Fig. 1). Save all the hardware.

3. Install the index lever to the new lever (Fig. 1).

4. Attach the new lever to the pivot support using the bolt

(1/2 x 1 in.) and jam nut (1/2 in.). Screw the bolt into

the pivot support until the handle is snug and then

back it off slightly to let the handle pivot freely

(Fig. 1).

5. Rotate the lever to align the hole at the bottom of the

handle with the control rod.

6. Insert the control rod through the handle end and

secure it with a large hairpin cotter (Fig. 1).

m–5699

Figure 1

1. Lever

2. Control rod

3. Large hairpin cotter

4. Index lever

5. Z-fitting

6. Bolt, 1/4 x 1 in.

7. Cable clip

8. Locknut, 1/4 in.

9. Bolt, 1/2 x 1 in.

10. Jam nut, 1/2 in.

PAGE 1
Form No. 3327–134 Adapter Kit 2002 and Later Snow/Dozer Blade to 2001 and Earlier GT Classic Garden Tractor Part No. 105–1501 Installation Instructions Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. USE Lever 1 Installing the New Lever Cable 1 Installing the New Cable Installing the New Lever 1. Disengage the power take off (PTO), set the parking brake and turn the ignition key to off. Remove the key. 5 2.
PAGE 2
Installing the New Cable 4 3 1. Thread the balled end of the cable through the keyhole slot in the frame up to the fitting on the cable jacket (Fig. 2). 1 2. Slide the fitting through the slot and push it to the right, ensuring there is a jam nut (1/2 in.) on each side of the frame (Fig. 2). 1 2 4 3. Connect the Z-fitting on the end of the cable to the release lever (Fig. 1). m–5043 Figure 3 1. Cable bracket 2. Cable 3. Angle pin 1 4. Cotter pin, 1-1/4 in. (32 mm) 6.