Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 105-1682

Form No. 3326-341

Muffler, Spark Arrester, and

Air Deflector Kit

Part No. 105-1680, 105-1681, and 105-1682

Installation

Instructions

Z-Master



Traction Units

Important When finished installing the spark arrester, store this sheet with your traction unit Operator’s Manual for

future reference.

Loose Parts

Note: Use the chart below to identify parts for assembly.

Description Qty. Use

Muffler

Gasket

Installing the muffler

Spark arrester

Clamp

Installing the spark arrester

Air deflector

Bolt

Locknut

Installing the air deflector

Installing the Muffler

1. Stop the PTO, set the parking brake, stop the engine,

and remove the ignition key.

2. Allow the traction unit to cool completely.

3. Remove the muffler heat shield.

4. Remove the four nuts and lock washers securing the

muffler to the studs on the engine.

5. Remove the old muffler and gaskets from the engine,

ensuring that you clean all pieces of the gaskets off of

the engine exhaust manifold.

6. Slide the new gaskets over the studs on the engine.

7. Install the new muffler on the studs on the engine,

securing it tightly using the lock washers and nuts

removed in step 4.

8. Install the muffler heat shield.

Installing the Spark Arrester

1. Slide the slotted end of the spark arrester over the

exhaust outlet on the muffler as far as possible by hand

(Fig. 1).

Important Do not use a hammer or other instrument

to pound the arrester onto the exhaust outlet. Pounding on

the arrester will damage it.

Summary of content (2 pages)

PAGE 1
Form No. 3326-341 Muffler, Spark Arrester, and Air Deflector Kit Z-Master Traction Units Part No. 105-1680, 105-1681, and 105-1682 Installation Instructions Important When finished installing the spark arrester, store this sheet with your traction unit Operator’s Manual for future reference. Loose Parts Note: Use the chart below to identify parts for assembly. Description Qty.
PAGE 2
1 2 3 3 1 4 Figure 1 1. Spark arrester 2. Muffler exhaust outlet 2 3. Clamp 2. Slide the clamp over the arrester until it is flush with the slotted end of the arrester so that the clamp covers the slots in the arrester (Fig. 1). 3. Tighten the clamp. m–5363 Figure 2 1. Frame 2. Air deflector 3. Bolt 4. Locknut Installing the Air Deflector 4. Secure the air deflector using the 2 bolts and locknuts provided (Fig. 2). If your traction unit already has an air deflector installed (Fig.