Installation Instructions

 2004—The Toro Company

8111 Lyndale Ave., Bloomington, MN 55420, USA

Printed in the USA

Original Instructions (EN)

Light Kit

Greensmaster



3050 and 3100

Part No. 105-3848

Form No. 3327-362 Rev A

Installation Instructions

Preparing the Traction Unit

If you leave the key in the ignition switch,

someone could accidently start the engine and

seriously injure you or other bystanders.

Remove the key from the ignition and disconnect

the wire(s) from the spark plug(s) before you do

any maintenance. Set the wire(s) aside so that it

does not accidentally contact the spark plug(s).

Caution

1. Disconnect the negative (–) battery cable from the

battery.

2. Remove the left cover plate (Fig. 1).

Figure 1

1. Left cover plate

2. Lockout bracket

3. Rear bolt

3. Remove and discard the rear bolt securing the lockout

bracket to the frame (Fig. 1). Save the washer and

locknut.

4. Remove the cover shield from the side of the control

panel (Fig. 2).

Figure 2

1. Cover shield 2. Control panel

Installing the Light Switch

(Greensmaster 3050 only)

1. Remove the plastic plug from the control panel

(Fig. 3).

Figure 3

1. Plastic plug

PAGE 1
Form No. 3327-362 Rev A Light Kit Greensmaster 3050 and 3100 Part No. 105-3848 Installation Instructions Preparing the Traction Unit 4. Remove the cover shield from the side of the control panel (Fig. 2). Caution 1 2 If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure you or other bystanders. Remove the key from the ignition and disconnect the wire(s) from the spark plug(s) before you do any maintenance.
PAGE 2
. Install the light switch into the control panel, securing it with 2 nuts and a lockwasher (Fig. 4). 2. Route the wire harness through the tubular light bracket so that the connectors on the harness for the lights are on either end of the bracket (Fig. 6). 2 3 2 3 1 1 Figure 4 1. Light switch m–5810 2. Control panel Figure 6 1. Tubular light bracket 2. Wire harness 3.
PAGE 3
5. Loosely install an R-clamp, bolt (3/8 x 3 in.), and washer in the rear hole of the lockout bracket using the hardware you removed previously (Fig. 8). 9. Connect the black wire to the ground bolt on the frame (Fig. 9). 4 1 4 4 3 5 1 2 2 Figure 8 1. Wire harness 2. R-clamp 3. Bolt, 3/8 x 3 in. 4. Cable tie 5. Washer 6. Route the harness through the R-clamp, under the left cover plate and up under the control panel (Fig. 8). Figure 9 7.
PAGE 4