Installation Instructions

1
All Rights Reserved
Printed in the USA
 2002 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Fuel Tank Fittings Kit
100 and 200 Series Z Master without Electronic Fuel
Injection
Part No. 105–9362
Form No. 3327–621
Installation Instructions
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Fuel bulkhead fitting
Hose
Grab Tool
Thread locker
2
1
1
1
Installing the bulkhead fittings
Draining The Fuel Tank
Gasoline is harmful or fatal if swallowed.
Long–term exposure to vapors can cause serious
injury and illness.
• Avoid prolonged breathing of vapors.
• Keep face away from nozzle and gas tank or
conditioner bottle opening.
• Keep gas away from eyes and skin.
Warning
Danger
In certain conditions, gasoline is extremely
flammable and highly explosive. A fire or
explosion from gasoline can burn you and others
and can damage property.
• Drain gasoline from the fuel tank when the
engine is cold. Do this outdoors in an open area.
Wipe up any gasoline that spills.
• Never smoke when draining gasoline, and stay
away from an open flame or where a spark may
ignite the gasoline fumes.
Note: Fuel tanks hold up to 6 gallons of fuel each.
1. Park the machine on a level surface, to ensure the fuel
tank drains completely. Then disengage the power take
off (PTO), set the parking brake, and turn the ignition
key to off. Remove the key.
2. Close the fuel shut–off valve (Fig. 1).
3. Loosen the hose clamp at the fuel filter and slide it up
the fuel line away from the fuel filter.
4. Pull the fuel line off fuel filter. Open fuel shut-off
valve and allow gasoline to drain into a gas can or
drain pan.
Note: Now is the best time to install a new fuel filter
because the fuel tank is empty.
5. Repeat these procedures for the opposite fuel tank.
6. Install the fuel line onto the fuel filter. Slide the hose
clamp close to the fuel filter to secure the fuel line.
1
Figure 1
1. Fuel shut-off valve