Installation Instructions

Printed in the USA

 2002 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

EFI Fuel Line Conversion Kit

200 Series Z Master with Electronic Fuel Injection

Part No. 105–9385

Form No. 3327–793

Installation Instructions

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Connector, 1/4 x 5/16 in.

Fuel hose extension

Hose clamp—Oetiker



Installing the connector

Important

Installation of hose clamps require special

pliers. Contact an Authorized Kohler Service Dealer or

tool suppliers for ordering Oetiker pliers.

Removing the Existing Fuel

Filter

Gasoline is harmful or fatal if swallowed.

Long–term exposure to vapors can cause serious

injury and illness.

• Avoid prolonged breathing of vapors.

• Keep face away from nozzle and gas tank or

conditioner bottle opening.

• Keep gas away from eyes and skin.

Warning

Danger

In certain conditions, gasoline is extremely

flammable and highly explosive. A fire or

explosion from gasoline can burn you and others

and can damage property.

• Wipe up any gasoline that spills. Do this

procedure outdoors in an open area.

• Never smoke when draining gasoline, and stay

away from an open flame or where a spark may

ignite the gasoline fumes.

1. Park the machine on a level surface. Then disengage

the power take off (PTO), set the parking brake, and

turn the ignition key to off. Remove the key.

2. Turn the fuel shut–off valve to the off position (Fig. 1).

PAGE 1
Form No. 3327–793 EFI Fuel Line Conversion Kit 200 Series Z Master with Electronic Fuel Injection Part No. 105–9385 Installation Instructions Loose Parts Note: Use the chart below to identify parts for assembly. QTY. DESCRIPTION Connector, 1/4 x 5/16 in. 1 Fuel hose extension 1 Hose clamp—Oetiker 3 Important Installation of hose clamps require special pliers. Contact an Authorized Kohler Service Dealer or tool suppliers for ordering Oetiker pliers.
PAGE 2
4. Remove the hose clamps from the fuel filter (Fig. 3). 5. Remove the hoses from the fuel filter (Fig. 3). Discard the fuel filter. 2 6. Remove the fuel filter hose from the fuel shut off valve. Discard this hose and clamps. 1 Installing the Connector Figure 1 1. Fuel shut-off valve Warning 2. Off position Fuel system components are under high pressure. Use of improper components can result in system failure, gasoline leakage and possible explosion.
PAGE 3
4 7 2 4 4 3 7 4 6 1 8 5 4 m–6042 Figure 3 1. Fuel shut–off valve 2. Fuel filter—remove 3. Connector—install 4. Hose clamp 5. Fuel hose extension—install 6. R–clamp 7. Fuel pump hose 8. Fuel filter hose—remove Checking for Leaks 9. Repeat this installation kit if any leaks are observed (Fig. 1). Important secured. 10. If no leaks are observed, install the front control panel (Fig. 2). Make sure all hoses and clamps are 1.
PAGE 4