Installation Instructions

Printed in the USA

 2002 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Wiehle Roller Scraper Kit

Greensmaster



3250-D w/Groomer

Part No. 105-9788

Form No. 3328–160

Installation Instructions

If you leave the key in the ignition switch,

someone could accidently start the engine and

seriously injure you or other bystanders.

Remove the key from the ignition before you do

any maintenance.

Caution

1. Slide a clamp block onto each end of the roller shaft.

Position the clamp blocks so that the threaded hole is

on top and facing forward (Fig. 1).

2. Thread a nut onto each scraper rod (Bottom out nut).

3. Insert both scraper rods through the clamp blocks.

Loosely secure the scraper rods to the clamp blocks

with a nut (Fig. 1).

4. Partially thread a screw into the front of each clamp

block (Fig. 1).

5. Position scraper between groomer and front roller.

6. Tighten the screws securing the clamp blocks to the

roller shaft (Fig. 1).

7. Adjust the nuts on each scraper rod until there is a

clearance of approximately 1/32 in. (0.8 mm) between

the scraper and the roller. Make sure that the scraper is

parallel to the roller.

Figure 1

1. Front roller shaft (left end)

2. Front roller

3. Clamp block

4. Scraper rod

5. Screw