Installation Instructions

3
16. Using the dimensions shown in figure 5, locate, mark
and drill (2) 11/32 inch holes thru both the walls of the
deck frame tube. The new top holes should align with
the current hinge mounting holes in the bottom of the
tube.
1–1/2”
1–1/2”
Figure 5
17. Mount the new clutch bracket and the previously
removed hinge to the frame tube with (2) capscrews
(5/16–18 x 3–1/4 inch), 4 washers (11/32 x 11/16) and 2
locknuts (5/16–18). Position the washers next to the
screw head and the nut (Fig. 6). Make sure to use the
correct bracket.
1
2
Figure 6
1. Clutch bracket (L.H.) 2. Hinge
18. Secure the top of the clutch to the clutch bracket with a
capscrew (7/16–20 x 1–1/2 inch), 3 washers, a spacer
and a lock nut (7/16–20). Position the components as
shown in figure 7.
1
2
2
2
3
4
5
Figure 7
1. Capscrew
2. Washer
3. Spacer
4. Clutch bracket (L.H.)
5. Locknut
19. Secure the clutch wire harness to clutch bracket with a
cable tie as shown in figure 8.
1
2
Figure 8
1. Clutch wire harness 2. Cable tie
20. Plug the clutch wire harness into the traction unit wire
harness.
21. Repeat the procedure on opposite side the of cutting
unit.
22. Reinstall the belt cover.