Installation Instructions

Printed in the USA

 2002 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Sprayer Adapter Kit

Workman



3000/4000

Part No. 106–2510

Form No. 3328–143

Installation Instructions

Note: When installing the Manual Spray System on a

Workman Vehicle which has a serial number greater than

220000001, the following instructions must be used in

conjunction with the set–up instructions supplied with the

system.

Complete the first three sections of this

instruction sheet before mounting the saddle on

vehicle.

Install Radiator Hose

1. Drain radiator.

• If engine has been running, pressurized hot

coolant can escape when radiator cap is

removed and cause burns.

Caution

2. Remove clamps securing radiator hose to engine and

radiator.

3. Remove and discard radiator hose.

4. Install new hose with clamps removed.

Important To prevent engine over–heating, replenish

radiator per instructions in Workman Operator’s Manual.

Figure 1

1. Radiator hose

Mount Spacer Blocks

1. Using dimensions shown in figure 2, locate, mark and

drill a .406” dia. hole in the bottom of right frame angle

of sprayer skid. Hole to be centered on frame angle.

36”

Figure 2

2. Repeat procedure on left frame angle.

3. Mount a spacer block to each frame rail with a hex

socket screw and whiz lock nut (Fig. 3). Spacer blocks

to be positioned with the screw to the front.

Figure 3

1. Spacer block

PAGE 1
Form No. 3328–143 Sprayer Adapter Kit Workman 3000/4000 Part No. 106–2510 Installation Instructions Mount Spacer Blocks Note: When installing the Manual Spray System on a Workman Vehicle which has a serial number greater than 220000001, the following instructions must be used in conjunction with the set–up instructions supplied with the system. 1. Using dimensions shown in figure 2, locate, mark and drill a .406” dia. hole in the bottom of right frame angle of sprayer skid.
PAGE 2
Install Pivot Plates 4. Remove the rear clinch nut from the top of each frame rail on vehicle (Fig. 4). 1. Remove bolts, washers and nuts securing the rear pivot plates to sides of sprayer skid (Fig. 6). 1 1 Figure 4 Figure 6 1. Clinch nut location 1. Rear pivot plate 5. Mount a spacer block to each frame rail with a hex socket head screw and whiz lock nut (Fig. 5). Spacer blocks to be positioned with the screw to the rear. 2.
PAGE 3
4. Secure rear brackets to vehicle frame with pins and lynch pins (Fig. 8). 1 1 3 2 1 Figure 8 1. Rear brackets 2 2. Pin and lynch pins Figure 9 Note: If saddle does not rest on all spacer blocks, loosen pivot plate mounting fasteners until saddle rests on spacer blocks, then re–tighten fasteners. 1. Prop rod support 2. Prop rod 3. Yoke The remaining instructions replace similar installation instructions supplied with the sprayer system. Mount Spacer Blocks 1.
PAGE 4