Installation Instructions

2
Installingthepumpshroud
Partsneededforthisprocedure:
1
Shroudbracket
2
Shroud-pumpdrive
4
Flangebolt(1/4x1/2inch)
4
Flangenut(1/4inch)
Procedure
Installthepumpshroudtocoverthepumpdrive.
1.Loosenthetwopumpboltsinthepumpfaceand
installtheshroudsupportasshowninFigure2.
Figure2
1.Shroudsupport4.Flangebolt(1/4x1/2inch)
2.Pumpbolt(9x10mm)5.Flangenut(1/4inch)
3.Springlockwasher6.Shroud
2.Tightenboltstosecuretheshroudsupport.
3.AssembletheshroudasshowninFigure2usingthe
fourangebolts(1/4x1/2inch)andfourange
nuts(1/4inch).
3
InstallingthePressureGauge
Partsneededforthisprocedure:
1Pressuregauge
Procedure
Replacetheexistingpressuregaugewiththenewgauge
capableofdisplayingpressureinkPa.
1.Usingawrench,holdthereducerattheteebracket
andloosentheexistingpressuregauge.Removethe
gauge(Figure3).
Figure3
1.Pressuregauge3.Teebracket
2.Reducer4.Reducernutandcoupler
2.Applysealertapetothreadsofthenewpressure
gaugeandinstallitintothereducer.Useawrench
toholdreducerwhiletighteningthenewpressure
gauge.
3.Positionthegaugesoitcanbeviewedbythe
operator.
Note:Thereducernutmayneedtobeloosenedandthe
wholeassemblyturnedtoallowthegaugetobeviewed.
4