Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 106-5470

Printed in the USA

 2002 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

52 Discharge Chute Retrofit Kit

100 Series Z Master

200 Series Z Master

Part No. 106–5470

Part No. 106–5451

Form No. 3328–102

Installation Instructions

Loose Parts

Description Qty. Use

Discharge bracket

Bolt, 5/16 x 3/4 inch

Flange nut, 5/16 inch

Installing the discharge bracket

Grass deflector

Spacer

Spring

Bolt, 5/16 x 7–1/2 inch

Locknut, 5/16 inch

Installing the grass deflector

An uncovered discharge opening could allow the

lawn mower to throw objects in the operator’s or

bystander’s direction and result in serious injury.

Also, contact with the blade could occur.

Never operate the lawn mower unless you install a

cover plate, a mulch plate, grass deflector, or a

grass chute and catcher.

Warning

Removing the Existing Grass

Deflector

1. Remove the existing grass deflector and defector

mounts (Fig. 1). Discard the grass deflector and mounts.

m–2549

Figure 1

1. Bolt

2. Deflector mount

3. Spring

4. Cone Locknut

5. Pivot Bracket

6. Carriage Bolt

7. Locknut

2. Thoroughly clean the mower discharge opening. All

debris must be removed to ensure the discharge bracket

will fit properly against the mower.

3. Repair all bent or damaged areas of mower and replace

any missing parts.

Summary of content (4 pages)

PAGE 1
Form No. 3328–102 52 Discharge Chute Retrofit Kit 100 Series Z Master 200 Series Z Master Part No. 106–5470 Part No. 106–5451 Installation Instructions Loose Parts Description Qty.
PAGE 2
Installing the Deflector Bracket 2 4 2 Note: If they are installed, remove any bolts from the bagger tunnel baffles that interfere with the installation of the discharge bracket. 5 Note: There are no existing holes in the mower to use for installing the deflector bracket. 3 1. Place the discharge bracket on top of the discharge tunnel (Fig. 2). 2. Align the discharge bracket flush with the outside of the discharge tunnel (Fig. 2).
PAGE 3
Important The grass deflector must be able to lower down into position. Lift the deflector up to test that it lowers into the full down position. 3 8 6 4 2 3 5 1 2 1 m–6151 Figure 5 7 1. Deflector bracket 2. DFS Bagger holes 3. Soft Bagger holes m–5037 Figure 4 1. 2. 3. 4. 5. Bolt, 5/16 x 7–1/2 inch Spacer Locknut, 5/16 inch Spring Spring installed 1. For the Soft Bagger, refer to Installing the Baffles for the Z Master DFS Baggers Only on page 3. 6. Grass Deflector 7.
PAGE 4
3. Install the front tunnel baffle to the mower and the deflector bracket using one bolt (5/16 x 3/4 inch) and a flange nut (5/16 inch) (Fig. 6). Installing the Baffles for the Z Master Soft Baggers Only Important Make sure the bolt head is installed on the inside of the cutting chamber. See Figure 6. Note: This section is only needed when installing the front and rear baffles for a Z Master Soft Bagger.