Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 106-7020

Printed in the USA

 2003 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Anti-Scalp Roller Kit

38 and 42 inch Mowers for TimeCutter Z Riding Mower

Model No. 106–7020 and 106–7027

Form No. 3329–343

Installation Instructions

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use the chart below to identify parts for assembly.

Description Qty. Use

Gage wheel bracket, front right

Gage wheel bracket, front left

Gage wheel

Wheel bolt

Lock nut, 3/8 inch

Assembling the gage wheels

Bolt, 5/16 x 5/8 inch

Flange nut, 5/8 inch

Installing the gage wheel bracket, 38 inch

Bolt, 5/16 x 5/8 inch

Flange nut, 5/8 inch

Installing the gage wheel bracket, 42 inch

Assembling the Gage Wheels

1. Assemble the gage wheel and the bracket using the

wheel bolt and lock nut, 3/8 inch (Fig. 1). Use the same

hole for both brackets.

2. Repeat step one for the other bracket and wheel.

m–6670

Figure 1

Left gage wheel assembly for 42 inch deck shown

1. Gage wheel

2. Gage wheel bracket

3. Locknut

4. Wheel bolt

Adjusting the Gage Wheels

The front mower wheels are to guide the mower over

uneven ground. The front wheel height can be changed to

closely match the selected height of cut for the mower.

1. To change the height of the mower front wheels,

remove the wheel mounting bolt and change the hole

into which the wheel is mounted (Fig. 1).

2. Use the top hole for the lowest cutting height and the

bottom hole for higher cutting heights (Fig. 1).

Summary of content (2 pages)

PAGE 1
Form No. 3329–343 Anti-Scalp Roller Kit 38 and 42 inch Mowers for TimeCutter Z Riding Mower Model No. 106–7020 and 106–7027 Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Note: Use the chart below to identify parts for assembly. Qty.
PAGE 2
Installing the Wheel Brackets 1. Stop the engine and remove the ignition key. Note: The 38 inch deck will use four bolts for the left gage wheel bracket. 2. Raise the mower to the G position [4-1/2 inch (114 mm)]. See the mower Operator’s Manual for raising the mower. 4. Lower the mower. 3. Mount the brackets onto the deck using the bolts, 5/16 x 5/8 inch and flange nuts, 5/16 inch (Fig. 2 and 3). 3 3 4 4 1 3 4 m–6672 2 Figure 2 38 inch deck shown 1. Right gage wheel 2. Left gage wheel 3.