Installation Instructions

ManualsBrandsToro ManualsCompact LoaderToro 106-7720

W 2004 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

Track Guide Refit Kit

Dingo TX 425 Wide Track Compact Utility Loader

Model No. 106-7720, 106-7721, 106-7722

Form No. 3351-896

Installation Instructions

Determine the left and right sides of the traction unit from the operator’s position.

Loose Parts

Description Qty. Use

Track guide

Road wheel

Snap ring, internal

Gasket

Bolt, 5/8 x 1-1/2 inch

Wheel cap

Guide adapter plate, right-hand

Guide adapter plate, left-hand

Carriage bolt, 1/2 x 1-1/4 inch

Locknut, 1/2 inch

Clamp plate

Hex flush screw, 1/2 x 1-1/2 inch

Bolt, 1/2 x 1-1/4 inch

Lockwasher, 1/2 inch

Track

Install the track guide.

Used in track guide refit on machines within Serial No. range 220000001-220000400 only.

Summary of content (4 pages)

PAGE 1
Form No. 3351-896 Track Guide Refit Kit Dingo TX 425 Wide Track Compact Utility Loader Model No. 106-7720, 106-7721, 106-7722 Installation Instructions Determine the left and right sides of the traction unit from the operator’s position. Loose Parts Description Qty.
PAGE 2
Track Guide Refit: Installing the Track Guide Serial No. 220000001- 220000400 1. Assemble the new track guide and wheels as shown in Figure 2. The Dingo TX 425 Compact Utility Loaders with serial numbers that range from 220000001 to 220000400 have an offset track guide and this kit contains both left-hand and right-hand adapter plates. The following procedure depicts the track guide refit on the left-hand side; however, it can be used to refit the track guide on either side. 2.
PAGE 3
8. Install three carriage bolts (1/2 x 1-1/4 inch) to the adapter plate before installing the plate to the track guide (Fig. 3). 10. Install the track guide assembly to the machine using two bolts (1/2 x 1-1/4 inch) and two lock washers (1/2 inch) down through the frame to the adapter plate of the track guide assembly (Fig. 4). Important Ensure the notch in the track guide is pointing toward the rear of the machine.
PAGE 4
3. Remove the track from the machine. Refer to the Operator’s Manual for more information. 3. Torque the road wheel bolt to 135 to 165 ft-lb (183 to 223 N⋅m). 4. Remove the 4 bolts and 4 lock washers securing the existing track guide to the frame (Fig. 5). Remove the track guide and fasteners and discard. 4. Install the new road wheel onto the track guide using the gasket in the kit and the bolt (5/8 x 1-1/2 inch) as shown in (Fig. 6). 5.