Installation Instructions

ManualsBrandsToro ManualsRiding ProductsPedal Switch Kit, Workman 1100, 2100 and 2110 Vehicles

 2003 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

Pedal Switch Kit

Workman 1100, 2100, and 2110 Vehicles

Model No. 107–0340

Form No. 3350-207

Installation Instructions

Loose Parts

Description Qty. Use

Switch

Plate tapped

Electrical sealant

Heat shrink tube

Screw (3/8 x 5/8 inch)

Replacing the pedal switch

Preparing the Vehicle

Position the machine on a level surface, stop the engine,

remove the key, and disconnect the negative (–) battery

terminal. Engage the parking brake.

If you leave the key in the ignition switch, someone

could accidently start the engine and seriously

injure you or other bystanders.

Remove the key from the ignition switch before

you do any maintenance.

Caution

Replacing the Pedal Switch

1. If you have a floor mat, remove it from around the

accelerator and brake pedals.

2. Remove the metal plate on the floor surrounding the

pedals.

3. Remove switch from pedal box. If necessary, drill out

the rivets securing the switch to the pedal box.

4. Pull the switch and cabling out, away from the pedal

box.

5. Disconnect the faulty switch and discard.

6. Clean the connector from the cabling of any debris or

foreign material.

7. Slide the heat shrink tubing over the cabling.

8. Pack the new switch connector with electrical sealant

provided in the kit (Fig. 1).

m–6946

Figure 1

1. Switch

2. Electrical sealant

3. Mounting holes

9. Pack the connector with the electrical sealant.

10. Connect the switch to the connector in the cabling.

11. Disconnect the switch from the connector and repack

both with electrical sealant.

12. Repeat steps 10 and 11 until the switch and connector

are packed with sealant; approximately 2–3 times.

Summary of content (2 pages)

PAGE 1
Form No. 3350-207 Pedal Switch Kit Workman 1100, 2100, and 2110 Vehicles Model No. 107–0340 Installation Instructions Loose Parts Description Qty. Switch 1 Plate tapped 1 Electrical sealant 1 Heat shrink tube 1 Screw (3/8 x 5/8 inch) 2 Preparing the Vehicle Use Replacing the pedal switch 8. Pack the new switch connector with electrical sealant provided in the kit (Fig. 1).
PAGE 2
18. Mount the switch using 2 screws (3/8 x 5/8 inch) and the tapped plate to secure it to the pedal box. 13. Once connected, pack the rear end of the cable connector with electrical sealant to prevent debris or foreign material from entering (Fig. 2). Note: The pedal switch can be mounted using rivets if desired. 1 Completing the Installation 3 1. Install the metal plate surrounding the pedals. 4 2. Install the floor mat if necessary. 3. Reconnect the negative (–) battery terminal.