Installation Instructions

 2003—The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
Printed in the USA
All Rights Reserved
Original Instructions (EN)
Weight Kit
Power Max Snowthrowers
Model No. 107-3815
Form No. 3350-778
Installation Instructions
Use the weight kit when you install the optional snow cab
on a Power Max snowthrower.
Save these instructions with your Operator’s Manual for
future reference.
Operating a Power Max snowthrower with a snow
cab without properly installing a counterweight to
the front of the snowthrower can cause it to tip
backward and fall on the operator, causing injury.
• Do not operate a snowthrower that has a snow
cab but does not have the proper
counterweight.
• Install this weight kit to the front of the
snowthrower in order to balance the added
weight of the snow cab.
Warning
Contents of the Kit
DESCRIPTION QUANTITY
Weight bar 1
Bolts 2
Washers 4
Nuts 2
Spacers 2
Installing the Weight Bar on
the Snowthrower
1. Disconnect the wire from the spark plug.
Note: For snowthrowers with a covered 2-cycle
engine, remove the ignition key.
2. Center the weight bar on the top of the auger housing
(Fig. 1).
1
2
3
4
5
6
4
7
Figure 1
1. Weight bar
2. Auger housing
3. Bolt (2)
4. Washer (4)
5. Spacer (2)
6. Nut (2)
7. Bend in the auger housing
3. Mark the locations where you will need to drill
2 holes.
Note: Mark each hole one inch (2.5 cm) behind the
bend in the auger housing.
4. Drill 2 holes (11/32 inch) in the auger housing at the
locations you marked.
5. Align the holes in the weight bar with the holes in the
auger housing.
Important Ensure that the danger decal on the weight
bar is visible.
6. Secure the weight bar to the auger housing with
2 bolts, 4 washers, 2 spacers, and 2 nuts provided in
the kit.
7. Connect the wire to the spark plug or insert the
ignition key.