Installation Instructions

Form No. 3355-309 Rev A
Drift Breaker Kit
For Power Max® Snowthrowers
Model No. 107-3816
Model No. 107-3817
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
Template
1
Side breaker
2
Top breaker
1
Carriage bolt, (5/16 x 3/4 inches)
4
Carriage bolt, (5/16 x 1 inch)
2
1
Locknut, 5/16 inch
6
Install the drift breaker on the
snowthrower.
Note: Visit www .T oro .com and do wnload the F renc h Operator’ s Manual that cor responds to the model
and serial n umber of the product on whic h this kit is installed.
Step
1
Installing the Drift Breaker
on the Snowthrower
Parts needed for this step:
1
Template
2
Side breaker
1
Top breaker
4
Carriage bolt, (5/16 x 3/4 inches)
2
Carriage bolt, (5/16 x 1 inch)
6
Locknut, 5/16 inch
Procedure
1. T rim off the template along the dotted line .
2. P osition the template (printed side out) on the
right side of the aug er housing aligning the
dotted line (previously cut) edg e with the top
of the aug er housing and the right side of the
template with the front edg e of the housing
( Figure 1 ).
Figure 1
1. Carriage bolt, 5/16 x 3/4
inches (4)
5. Top edge of side breaker
2. Side breaker (2)
6. Top breaker
3. Template
7. Locknut (6)
4. Carriage bolt, 5/16 x 1 inch
(2)
3. Secure the template in place with tape and
center punc h through the hole on the template
and onto the sno wthro w er side frame .
4. Measure 4 inc hes (10.2 cm) do wn along the
diag onal line and mark the spot on that line .
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved