Installation Instructions

4
3. Install the left and right supports to the frame and
secure them using the fasteners removed previously. Do
not tighten the fasteners at this time (Fig. 6).
m–7527
9
2
4
10
5
7
8
11
1
3
6
12
Figure 6
1. Base bracket
2. Left support
3. Right support
4. Top support
5. Flange nut, 5/16 inch
6. Bolt, 5/16 x 3/4 inch
7. Bolt, 3/8 1-1/4 inch
8. Locknut, 1/4 inch
9. Radiator
10. Frame
11. Foam angle
12. Bulb seal, upper
4. Transfer the upper bulb seal to the top support (Fig. 6).
5. Install the top support to the left and right supports
using two bolts (5/16 x 3/4 inch) and two locknuts
(5/16 inch) supplied in loose parts. Do not tighten the
fasteners at this time (Fig. 6).
6. Install the radiator into the supports using the four bolts
(5/16 x 5/8 inch) and lock nuts (5/16 inch) removed
previously (Fig. 6).
7. Tighten all support fasteners.
Important Avoid stressing the radiator frame. Do not
over tighten fasteners.
8. Install the foam angles to seal the open cavity between
the frame and support (Fig. 6).
9. Install the shroud into position and move the fan and
clutch assembly through the shroud opening toward the
engine.
10. Secure the fan and clutch assembly to the engine using
the fasteners removed previously.
11. Move the shroud over the fan, toward the radiator.
Secure the shroud to the radiator using the fasteners
removed previously.
12. Connect the coolant hoses to the radiator. Secure the
hoses using the existing clamps.
13. Connect the overflow hose from the overflow tank to
the radiator.
Finishing the installation
1. Attach the air cleaner hose to the radiator support.
2. Flush the coolant system with water to remove any
debris that may have entered the system during the
installation.
3. Close the radiator drain.
4. Fill the coolant system with the proper mix of coolant.
Refer to your Operator’s Manual for a listing of the
required coolant.
5. Test run the engine for any leaks.
6. Install the hood support rod using the clevis and hair pin
removed previously.
7. Remove the blocks supporting the engine hood. Close
and lock the hood.