Installation Instructions

6
1
1
2
Figure 11
1. Suction hose piece 2. Manifold arm
23. Connect the old manifold hose and fitting to the
manifold arm orifice.
24. Connect the suction hose from the manifold arm to the
new manifold tube with a new hose clamp.
25. Tighten all clamps, hoses and fittings.
26. Mount the woodruff key, pulley and pulley bushing to
the pump shaft with the capscrews and washers
previously removed (Fig. 7).
27. Insert the belt onto the pump pulley (Fig. 6 & 7).
28. Position a large wrench on the tensioner. Rotate the
tensioner clockwise until the decal is aligned with 15_
on tensioner tube.
29. Insert capscrew into aligned guide holes and secure
with nut. If holes are not exactly aligned, rotate guide
to the next higher hole until aligned.
30. Tighten capscrew, on back side of frame, to lock
tensioner.
31. Install the drive shield to the impeller housing with the
capscrews, washers, and nuts.