Installation Instructions

ManualsBrandsToro ManualsAttachmentsCE Kit, 72in Side Discharge Mower for Groundsmaster 300 Series

FormNo.3351-941RevA

CEKit

for72inSideDischargeMowerforGroundsmaster

300Series

TractionUnits

ModelNo.108-1381

InstallationInstructions

Installthefollowingdecalandguardsonthe

Groundsmaster72inchsidedischargedeck.Usethe

locationdescriptionlistedbelowtodeterminethe

correctplacementontheproduct.Beforeinstallingthe

decal,removeorthoroughlycleantheEnglishdecal,

andapplytheappropriatetranslatedlanguageversionin

itsplace(oroverit).

Important:Shouldthedecalortheguardsbecomedamagedorillegible,replacethemimmediately.

Eachpartnumberislistedbelowandalsooneachdecal.Replacementsmaybeorderedthroughyour

authorizedTorodistributor.

InsertthefollowingLocationTableintothe

Operator’ s Man ual

fortheowner’sreference.

EnglishPartsDescriptionLocationEnglishPartNo.EuropeanPartNo.

Qty.

DangerDecal

OnDeector

43-8480106-67531

Bafe–RHUnderRHFrontofDeck

—

93-6604-011

Bafe–LHUnderLHFrontofDeck

—

93-6605-011

Bolt

RH&LHDeckCovers

—

323-72

OuterGuardAssemblyDriveShaft

—

93-99851

InnerGuardAssemblyDriveShaft

—

93-99651

RetainingRing

Inner&OuterGuardAssembly

——

NylonBushing

Inner&OuterGuardAssembly

——

CE—CerticateofCompliance

LoosePartsBag

—

115-45461

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (4 pages)

PAGE 1
Form No. 3351-941 Rev A CE Kit for 72in Side Discharge Mower for Groundsmaster® 300 Series Traction Units Model No. 108-1381 Installation Instructions Install the following decal and guards on the Groundsmaster 72 inch side discharge deck. Use the location description listed below to determine the correct placement on the product. Before installing the decal, remove or thoroughly clean the English decal, and apply the appropriate translated language version in its place (or over it).
PAGE 2
Installing the Baffles Note: Make sure the baffles are level and not bent. A bent baffle could affect the quality of cut. 1. Using the dimensions shown in Figure 1, locate, mark, and drill 7 holes (0.344 inch (9mm) dia.) in the front of the deck. 2. Loosely secure the right and left baffles to the inside of the deck with flange head bolts and flange nuts, positioning them as shown in Figure 1. 3. Adjust the baffles to the desired height and tighten the mounting fasteners.
PAGE 3
Installing the Drive Shaft Guard 2. Remove the grease fitting from the drive shaft slip yoke tube (Figure 2). Retain the grease fitting. 3. Remove the retaining ring and nylon bushing shipped in place in the inner drive shaft guard (Figure 2). 4. Slide the retaining ring all the way onto the drive shaft tube (Figure 2). 5. Insert the nylon bushing into the groove on the drive shaft tube (Figure 2). 6.
PAGE 4