Installation Instructions

1
All Rights Reserved
Printed in the USA
W 2005 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Conversion Kit
72in Guardian Recycler to Rear Discharge for
Groundsmaster 3320 and 3280–D
62in Guardian Recycler to Rear Discharge for
Groundsmaster 3320 and 3280–D
Part No. 108–1902
Part No. 108–1900
Form No. 3353–620 Rev B
Installation Instructions
1. Park the traction unit on a level surface, set the
parking brake, raise the deck to the highest position
and stop the engine. Remove the key from the ignition.
2. Block up the deck so it does not accidentally fall.
3. Remove the covers from the top of the deck.
4. Remove the capscrew, spacer and nut securing the rear
roller to the bracket (Fig. 1).
5. Remove the (3) carriage bolts and nuts securing the
roller bracket to the underside of the deck (Fig. 1).
6. Remove the carriage bolts and nuts securing the left
and right recycler chambers to the center chamber
(Fig. 1).
7. Remove the carriage bolts and nuts securing the left,
center and and right recycler chambers to the deck
(Fig. 1).
8. Thoroughly clean the underside of the deck.
1
2
3
5
6
4
Figure 1
1. Left chamber
2. Center chamber
3. Right chamber
4. Roller bracket
5. Roller 6. Roller spacer
9. Position the right, center and left rear discharge
chambers under the deck, aligning the mounting holes,
as shown in figure 2.
10. Secure the chambers to the deck with 5/16 x 3/4 in.
carriage bolts and nuts. The nuts are to be positioned
outside the deck (Fig. 2). Tighten all fasteners.