Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 108-2162

Form No. 3355-906 Rev A

Roller Striping Kit

For Z Master® TURBO FORCE® Mowers

Model No. 108-2162

Installation Instructions

Safety

Safety and Instructional Decals

Safety decals and instr uctions are easily visible to the operator and are located near any

area of potential dang er . R e place any decal that is damag ed or lost.

108-4108

1. Striping roller 3. Raise the striping roller.

2. Engage the striping roller.

8111 Lyndale Avenue South

Bloomington, MN 55420

Printed in the USA.

Summary of content (4 pages)

PAGE 1
Roller Striping Kit Form No. 3355-906 Rev A For Z Master® TURBO FORCE® Mowers Model No. 108-2162 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 108-4108 1. Striping roller 2. Engage the striping roller. © 2006—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 3. Raise the striping roller. Register at www.
PAGE 2
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Step 1 2 Use Qty. Description 2 1 2 2 2 1 1 2 1 1 2 2 Flange bushing Roller assembly Bolt (3/8 x 4-3/4 inches) Washer Spacer Right-hand spring Left-hand spring Locknut (3/8 inch) Control lever assembly Bolt (7/16 x 2 inches) Flange nut (7/16 inch) Locknut (3/8 inch) Install the roller. Install the control lever assembly.
PAGE 3
Step 2 Installing the Control Lever Assembly Parts needed for this step: 1 1 2 2 Figure 2 1. 2. 3. 4. Bolt (3/8 x 4-3/4 inches) Washer Spacer Right-hand spring 5. 6. 7. Left-hand spring Locknut (3/8 inch) Roller assembly Control lever assembly Bolt (7/16 x 2 inches) Flange nut (7/16 inch) Locknut (3/8 inch) Procedure 1. Remove the bolt and nuts securing the left rear mower deck mounting chain to the mower deck. 2.
PAGE 4
securing the chain between the locknuts near the top of the bolt (Figure 3). 5. Test the lever action by moving it back and forth. The roller should lift up and down.