Installation Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 108-2640

Form No. 3353-411 Rev A

Blower Liner Kit

For Z400 and Z500 Twin and Triple Baggers

Model No. 108–2639

Model No. 108–2640

Installation Instructions

Installation

Loose Parts

Use the chart below to verify that all parts have been shipped.

Step

Description

Qty.

Use

Blower liner

Fanged elevator bolt

Flat washer

Locknut

Replacing the Blower Liner

Step

Parts needed for this step:

Blower liner

Fanged elevator bolt

Flat washer

Locknut

Procedure

1. Diseng ag e the PTO , set the parking brak e , and

c hoc k or bloc k the dri v e wheels .

2. T ur n off the engine , remo v e the k ey , and w ait for all

mo ving par ts to stop before lea ving the operating

position.

3. R emo v e the ﬁv e bolts that hold the blo w er liner

to the blo w er ( Figure 1 and Figure 2 ). Discard the

hardw are .

4. Pull the liner out of the blo w er ( Figure 1 ).

Note: Do not use y our hands to remo v e the

debris .

5. R emo v e any debris from the blo w er .

6. Slide the new liner around the blo w er impeller .

T he new liner and f anged elev ator bolts

may ha v e shar p edges which could cut y our

hands or cause sli v er s. W ear g lo v es when

handling them.

7. Secure the liner to the rear of the blo w er with 3

fang ed elev ator bolts (5/16 x 1 inc h), ﬂat w ashers

and loc kn uts (5/16 inc h) ( Figure 1 ).

Figure 1

1. Blower 4. Washer, 5/16 inch

2. Liner

5. Locknut, 5/16 inch

3. Fanged elevator bolt, 5/16

x 1 inch

8111 Lyndale Avenue South

Bloomington, MN 55420

Printed in the USA.

Summary of content (2 pages)

PAGE 1
Form No. 3353-411 Rev A Blower Liner Kit For Z400 and Z500 Twin and Triple Baggers Model No. 108–2639 Model No. 108–2640 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Step 1 5 5 5 Blower liner Fanged elevator bolt Flat washer Locknut 1 Use Qty. Description Replacing the Blower Liner Step 1 The new liner and fanged elevator bolts may have sharp edges which could cut your hands or cause slivers. Wear gloves when handling them.
PAGE 2
8. Install 2 fanged elevator bolts (5/16 x 1 inch), ﬂat washers and locknuts (5/16 inch) into the liner and the blower (Figure 2). 10. While holding the liner, tighten the 2 top bolts in the liner and the blower (Figure 3). 11. Rotate the blower pulley to verify that the blower fan does not hit the liner (Figure 3). Adjust the liner if necessary. Figure 2 1. 2. Blower 3. Fanged elevator bolt, 5/16 4. x 1 inch Nut, 5/16 inch Impeller Figure 3 9.