Installation Instructions

 2004 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

Bagging Enhancement Kit

Z400 Series Z Master Mowers

Part No. 108–4091

Form No. 3353–234

Installation Instructions

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Right side rubber baffle

Left side rubber baffle

Metal baffle stiffener

Carriage bolt, 5/16 x 1 inch

Locknut, 5/16 inch

Installing the baffles

Preparing the Mower Deck

1. Position the mower on a flat surface.

2. Disengage the PTO, move the motion control levers to

the neutral locked position and set the parking brake.

3. Stop the engine, remove the key, and wait for all

moving parts to stop before leaving the operating

position.

4. Raise the mower to the transport position.

5. Lift the front of the machine and support the machine

using jack stands.

6. Thoroughly clean the mower deck. All debris must be

removed to ensure the baffle will fit properly against the

mower deck.

7. Repair all bent and damaged areas of the mower deck

and replace any missing parts.

Mechanical or hydraulic jacks may fail to support

the machine and cause a serious injury.

• Use jack stands when supporting the machine.

• Do not use hydraulic jacks.

Warning

PAGE 1
Form No. 3353–234 Bagging Enhancement Kit Z400 Series Z Master Mowers Part No. 108–4091 Installation Instructions Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Right side rubber baffle 1 Left side rubber baffle 1 Metal baffle stiffener 2 Carriage bolt, 5/16 x 1 inch 8 Locknut, 5/16 inch 8 USE Installing the baffles Preparing the Mower Deck 1. Position the mower on a flat surface. 2.
PAGE 2
Installing the Baffles 2. Install the right side rubber baffle and one of the baffle stiffeners with 4 bolts (5/16 x 1 inch) and 4 locknuts (5/16 inch) (Fig. 1). Note: Install bolts as shown in Figure 1. 3. Rotate the cutting blades and make sure they do not hit the baffles. 1. Install the left side rubber baffle and one of the baffle stiffeners with 4 bolts (5/16 x 1 inch) and 4 locknuts (5/16 inch) (Fig. 1). 1 6 3 4 6 5 4 5 2 m–7913 Figure 1 1. Mower deck 2. Left side rubber baffle 3.