Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 108-4141

Form No. 3353-909 Rev A

Trim/Discharge Side Anti-Scalp Roller Kit

For Z400 Series Z Master® Mowers

Model No. 108-4140

Model No. 108-4141

Installation Instructions

Installation

Loose Parts

Use the chart below to verify that all parts have been shipped.

Step

Description

Qty.

Use

Wheel bracket

Carriage bolt (3/8 x 3/4 inch)

Flange nut (3/8 inch)

Install the wheel bracket.

Wheel

Bolt (3/8 x 4-3/4 inches)

Long spacer 1

Short spacer

Flange nut (3/8 inch)

Install the wheel.

Step

Installing the Wheel Bracket

Parts needed for this step:

Wheel bracket

Carriage bolt (3/8 x 3/4 inch)

Flange nut (3/8 inch)

Procedure

1. Pre pare the installation site as follo ws:

• If y ou are re placing an existing anti-scalp

wheel, remo v e the wheel, wheel brac k et,

and all fasteners from the mo w er and

discard them.

• If y ou are installing the anti-scalp wheel for

the ﬁrst time , locate the three holes on the

rear trim or disc harg e side of the mo w er

(de pending on whic h kit y ou are installing)

and remo v e the three bolts and n uts that

are installed in the holes .

2. Install the wheel brac k et to the mo w er using 3

car riag e bolts (3/8 x 3/4 inc h) and ﬂang e n uts

(3/8 inc h) ( Figure 1 ).

Important: Ensur e that y ou install the

car ria ge bolts with the bolt heads on the

inside of the mo w er and the n uts on the

outside.

8111 Lyndale Avenue South

Bloomington, MN 55420

Printed in the USA.

Summary of content (2 pages)

PAGE 1
Form No. 3353-909 Rev A Trim/Discharge Side Anti-Scalp Roller Kit For Z400 Series Z Master® Mowers Model No. 108-4140 Model No. 108-4141 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Step 1 2 Description Wheel bracket Carriage bolt (3/8 x 3/4 inch) Flange nut (3/8 inch) Wheel Bolt (3/8 x 4-3/4 inches) Long spacer Short spacer Flange nut (3/8 inch) Step 1 3 3 1 1 1 1 1 Use Install the wheel bracket. Install the wheel.
PAGE 2
spacer/wheel assembly at the desired height (Figure 1). Note: Insert the bolt so that its head is toward the outside of the mower. 4. Secure the wheel with a ﬂange nut (3/8 inch) (Figure 1). Figure 1 1. Wheel bracket 2. Carriage bolt (3/8 x 3/4 inch) 3. Flange nut (3/8 inch) 4. Wheel 5. 6. Bolt (3/8 x 4-3/4 inches) Short spacer 7. Long spacer Step 2 Installing the Wheel Parts needed for this step: 1 1 1 1 1 Wheel Bolt (3/8 x 4-3/4 inches) Long spacer Short spacer Flange nut (3/8 inch) Procedure 1.