Installation Instructions

ManualsBrandsToro ManualsRiding ProductsSpeed Control Kit, Greensmaster 3150

Printed in the USA

W 2005 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Speed Control Kit

GreensmasterR 3150

Part No. 108–6472

Form No. 3353–648 Rev A

Installation Instructions

Installation

1. Under the traction pedal, loosen the jam nut securing

the stop bolt to the floor plate (Fig. 1). Remove and

retain the stop bolt and jam nut.

Figure 1

1. Stop bolt & jam nut

2. Position the speed control assembly onto the floor plate

aligning the front mounting hole in the base with the

hole vacated by the stop bolt (Fig. 2).

Figure 2

1. Speed control assembly

2. Front mounting hole

3. Rear mounting hole

4. Stop bolt & jam nut

3. Loosely attach the front of the speed control base to the

floor plate with the stop bolt and nut previously

removed. Make the sure the speed control pedal stop is

aligned with the traction pedal rod (Fig. 2 & 3).

4. If the rear mounting hole (Fig. 2) is not present, use the

hole in the rear of the speed control base as a template,

to locate, mark and drill a .277 in. dia. hole in the floor

plate.

5. Secure the rear of the speed control base to the floor

plate with the thread forming screw included (Fig. 2).

Figure 3

6. Re–adjust the pedal stop as follows:

• Put the functional control lever in the transport

position and loosen the locknut securing the pedal

stop.

• Tighten the pedal stop until it does not contact the

traction pedal.

• While applying a light load on the transport pedal,

adjust the pedal stop so it contacts the pedal rod and

tighten the nut.

Note: To decrease the maximum transport speed, raise the

stop bolt height.

Important The tension on the cable must not be

excessive or cable life will be reduced.

Summary of content (2 pages)

PAGE 1
Speed Control Kit Form No. 3353–648 Rev A GreensmasterR 3150 Part No. 108–6472 Installation Instructions Installation 3. Loosely attach the front of the speed control base to the floor plate with the stop bolt and nut previously removed. Make the sure the speed control pedal stop is aligned with the traction pedal rod (Fig. 2 & 3). 1. Under the traction pedal, loosen the jam nut securing the stop bolt to the floor plate (Fig. 1). Remove and retain the stop bolt and jam nut. 4.
PAGE 2
Operation 1. Move the speed control lever to the disengaged position (Fig. 4). 2. Loosen the indicator tab knob (Fig. 4). 3. Move the indicator tab knob to the desired operating speed. Moving the indicator forward will increase the operating speed, rearward will decrease the speed. Note: The increments on the decal are for reference only. The desired speed is determined by the mowing application 4. Securely tighten the indicator tab knob. 5. Move the lever to the engaged position (Fig.