Installation Instructions

Form 3353-568

Toro Workman Cab Update Kit 108-7030

4-14905

05-10518_update_feb_05

Update detailed request list, Dec. 28, 2004.

1. In the mount kit box; Rear seal flaps -change out the short seal flaps with the long seal flaps.

See Figure 1.

Figure 1

2. Front hood seal; Replace the small bubble rubber with the larger bubble rubber 108-3086.

See Figure 2

Figure 2

OLD

FLAP

SEALS

NEW FLAP

SEAL RH

108-7038

LARGER

BUBBLE

RUBBER

NEW FLAP

SEAL LH

108-7037

Page 1 of 5

PAGE 1
Form 3353-568 Toro Workman Cab Update Kit 108-7030 4-14905 Update detailed request list, Dec. 28, 2004. 1. In the mount kit box; Rear seal flaps -change out the short seal flaps with the long seal flaps. See Figure 1. NEW FLAP SEAL RH 108-7038 NEW FLAP SEAL LH 108-7037 OLD FLAP SEALS Figure 1 2. Front hood seal; Replace the small bubble rubber with the larger bubble rubber 108-3086.
PAGE 2
Form 3353-568 Toro Workman Cab Update Kit 108-7030 4-14905 Remove roof for steps 3 and 4. 3. Roof sealing; Remove underside rubber washers. See Figure 3. REMOVE WASHER Figure 3 4. Install profile corner seal pads (½” x 2 x 2) Part No. 108-7031. Install (4) Qty in front, (2) Qty in rear. See Figures 4a, 4b and 4c.
PAGE 3
Form 3353-568 Toro Workman Cab Update Kit 108-7030 4-14905 Figure 4b Figure 4c Page 3 of 5 05-10518_update_feb_05
PAGE 4
Form 3353-568 Toro Workman Cab Update Kit 108-7030 4-14905 5. Re-install roof. 6. Door seal issue; Add .312” X .750” adhesive seal to the front and top profile tube-door sealing surface, each side of cab. See Figure 6. Adjust hinges and striker stud if required.
PAGE 5
Page 5 of 5