Form No. 3369-202 Rev A Operator Fan Kit - US Sales Only For Select Commercial Grounds and Golf Products Only Model No. 110-1996 Model No. 110-8804 To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com.
Safety Introduction The following list contains safety information specific to Toro products and other safety information you must know. Read this information carefully to learn how to operate and maintain your product properly and to avoid injury and product damage. You are responsible for operating the product properly and safely. • Become familiar with the safe operation of the equipment, with the operator controls, and safety signs. You may contact Toro directly at www.Toro.
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 93–6681 1. Cutting/dismemberment hazard—stay away from moving parts.
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 Description Use Qty. Fan assembly U-bolt Locknut (3/8 inch) U-bolt plate Fuse holder Ring terminal Splice connector Fuse, 20 amp Cable ties 1 2 4 2 1 2 1 1 4 Install the fan assembly. Install the fan to the battery. Note: Determine the left and right sides of the machine from the normal operating position.
Figure 3 1. Fan and frame assembly 2. Locknut (3/8 inch) 3. U-bolt plate 4. 2 inch ROPS frame 5. U-bolt 2 Connecting the Fan to the Battery Figure 4 1. Battery with bolts in the posts 2. Ring terminal 3. White wire 4. Black wire Parts needed for this procedure: 1 Fuse holder 2 Ring terminal 1 Splice connector 1 Fuse, 20 amp 4 Cable ties 5. Splice connector 6. Fuse, 20 amp 7. Fuse holder 6. Install the white wire ring terminal to the negative post on the battery (Figure 4). 7.
Operation WARNING Running the fan continuously for more than 1 hour will discharge the battery. The battery discharge may prevent the machine from starting again or cause engine problems. Note: Determine the left and right sides of the machine from the normal operating position. WARNING • Do not use the fan for more than 1 hour straight at a time.
Maintenance Storage Cleaning the Fan Screen 1. Clean the attachment. Refer to Cleaning the Fan Screen. The screen needs to be cleaned before each use. 2. Inspect the attachment for damage. 1. Disengage the power take off (PTO) and set the parking brake. 3. Store the machine in a clean, dry place, out of direct sunlight. If you must store the machine outside, cover it with a weatherproof cover. This protects the plastic parts and extends the life of the machine. 2.
Troubleshooting Problem Abnormal vibration. Fan does not run. Possible Cause Corrective Action 1. Fan mounting bolts are loose. 1. Tighten the fan mounting bolts. 2. Blower fan blade(s) is/are bent or unbalanced. 2. Contact an Authorized Service Dealer. 1. Electrical connections are loose. 1. Tighten the electrical connections. 2. The battery is discharged. 3. The fuse is blown. 2. Recharge the battery. 3. Check the fuse and replace it if needed.
Notes: 9
Notes: 10
Notes: 11
The Toro Total Coverage Guarantee A Limited Warranty Conditions and Products Covered The Toro® Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).
