Installation Instructions

1
All Rights Reserved
Printed in the USA
W 2006 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Front Scraper Kit for Full Roller
Front Scraper Kit for Narrow Roller
Front Scraper Kit for Wide Roller
Greensmaster
)
DPA Cutting Units
Part No. 110–2352
Part No. 110–2351
Part No. 110–2350
Part No. 110–3962
Part No. 110–3961
Part No. 108–6468
Form No. 3357–755 Rev A
Installation Instructions
1. Remove the plow bolt, washer and flange nut securing
one of the height of cut (HOC) arms to the cutting unit
sideplate (Fig. 1).
2. Loosen the roller mounting screws in the HOC arms
(Fig. 1).
3. Slide the HOC arm off the roller shaft (Fig. 1).
4. Slide the roller shaft out of the HOC arm on the
opposite end of the cutting unit.
1
2
4
5
6
3
Figure 1
1. HOC arm
2. Adjusting screw
3. Plow bolt
4. Washer
5. Flange nut
6. Roller mounting screw
5. Loosely install a capscrew and nut onto each clamp
(Fig. 2). Do not tighten.
6. Insert a shaft clamp onto each end of the roller shaft
(Fig. 2).
1
2
Figure 2
1. Clamp 2. Scraper
7. Loosely install the roller to the cutting unit with the
HOC arm and fasteners previously removed.
8. Adjust to the desired height of cut and tighten HOC
arm mounting fasteners.
9. Position the scraper between the front roller and the
cutting unit as shown in the figure 2.
10. Center the scraper on the roller.
11. Move the scraper in or out until the desired roller
clearance is attained. Scraper must not contact roller.
Make sure the scraper is parallel to the roller.
12. Tighten the capscrews and nuts securing the clamps to
the roller shaft. Torque to 96 in–lbs.
13. Center the roller and scraper between the HOC arms.
14. Rotate the scraper down until the lowest edge is .25 in.
above the turf.
15. Tighten the roller mounting screws.