Installation Instructions

ManualsBrandsToro ManualsAeratorsReplacement Idler Kit, ProCore Processor

FormNo.3361-204RevA

ReplacementIdlerKit

ProCoreProcessor

ModelNo.110-2726

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Removeexistingidlerpulleyassembly

Idlerarm1

Carriagescrew,(1/2x4–1/2inch)

Assemblethepulleytotheidlerarm

Nopartsrequired

–

Mounttheidlerpivot

Eyebolt1

Hexnut(3/8inch)

Washer2

Flangenut(3/8inch)

Mountthespringeyebolt

Thrustwasher1

Retainingring1

Extensionspring1

Mounttheidlerpulleyassembly

RemoveExistingIdlerPulley

Assembly

NoPartsRequired

Procedure

1.Removetheengineclutchtojackshaftbeltcover

(Figure1).

Figure1

1.Engineclutchtojackshaftbeltcover

2.Removetheidlerpulleycover(Figure2).

Figure2

1.Idlerpulleybeltcover

3.Loosenthenutontheidlerpulley(Figure3).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (4 pages)

PAGE 1
Form No. 3361-204 Rev A Replacement Idler Kit ProCore Processor Model No. 110-2726 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description 1 2 3 4 5 Use Qty.
PAGE 2
Figure 3 1. Idler pulley Figure 4 2. Engine clutch to jack shaft belt 1. Idler arm 2. Pulley 3. Carriage screw 4. Remove the nut, washer and carriage screw securing the pulley and standoff to the frame. Remove the pulley assembly. Retain the pulley, washer and nut but discard the carriage screw. 4. Washer 5. Nut 2. Mount the pulley to the idler arm with the new 4–1/2 inch carriage screw and the previously removed washer and nut (Figure 4).
PAGE 3
4. Align the idler pivot mounting holes with the holes in the frame and bearing (Figure 5). 5. Secure the idler pivot to the frame and bearing with (4) new 2–1/4 inch carriage screws and the previously removed washers and nuts (Figure 5). 4 Mount the Spring Eye Bolt Figure 7 Parts needed for this procedure: 1. Eye bolt 2. Hex nut 3. Washer 4. Flange nut 1 Eye bolt 1 Hex nut (3/8 inch) 2 Washer 3. Insert a washer onto the eye bolt (Figure 7). 1 Flange nut (3/8 inch) 4.
PAGE 4
Note: To release the belt tension, insert a socket wrench into the square hole in the idler arm and rotate the wrench upward (Figure 10). 5 3. Check the operation and install the belt covers. Mount the Idler Pulley/Idler Arm Assembly Important: To assure proper machine operation and increased belt life, check the belt and tension frequently. If the idler arm extension spring stretches to more than 3.75 inches, replace the spring. Measure the spring from inside loop to inside loop as shown in Figure 11.