Installation Instructions

ManualsBrandsToro ManualsRiding ProductsAuxiliary Valve Kit, Groundsmaster 3320 and 3280-D Traction Unit

Printed in the USA

W 2005 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Auxiliary Valve Kit

Groundsmaster

)

3320 and 3280–D

Part No. 110–5670

Form No. 3354–187 Rev B

Installation Instructions

Note: Determine the left, right, front, and rear sides of the machine while seated in the normal operating position.

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Control Valve Assembly

Control Valve Pivot Lever

Control knob

Socket Head Screw 10–24 x 1–1/4” lg.

Locknut #10–24

Clevis Pin

Cotter Pin

Hydraulic Hose

Capscrew 1/4 – 20 x 2–3/4” lg.

Flange Locknut 1/4–20

Hydraulic Hoses

Protective Sleeve

Coupler bracket

Retaining Ring

Snap Ring

Dust Plug

Dust Cap

Quick Disconnect (coupler)

Quick Disconnect (nipple)

Cable tie

Installation instructions 1 Read before installing the kit.

Parts catalog 1

Summary of content (4 pages)

PAGE 1
Auxiliary Valve Kit Form No. 3354–187 Rev B Groundsmaster) 3320 and 3280–D Part No. 110–5670 Installation Instructions Note: Determine the left, right, front, and rear sides of the machine while seated in the normal operating position. Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Control Valve Assembly 1 Control Valve Pivot Lever 1 Control knob 1 Socket Head Screw 10–24 x 1–1/4” lg.
PAGE 2
1. Remove the seat and the seat base from the machine. Note: The fuel tank is very heavy when full. Make sure it is nearly empty before trying to remove it. 3.50 2. Loosen the fuel tank mounting fasteners so the fuel tank can be elevated enough to gain access to the right fender. 1.25 2.25 3. Locate the (3) holes in the right fender. • If the rear hole is located 3.74 inches from the edge of the fender as shown in figure 1, proceed to to step 4. 3.74 .344” dia. (3) Figure 3 1 4.
PAGE 3
7. Connect the steering hose (from the lift valve “P” port) to the 90_ fitting on the operator side of the control valve (Fig. 4). 10. Install the protective sleeve over the hoses (Fig. 5). The remainder of the hose installation will be completed later. 8. Connect the hydraulic hose (included in the kit) to the “P” port of the lift valve and to the 90_ fitting on the outer side of the control valve (Fig. 4). 11. Remove the drain pan from under the machine. 12.
PAGE 4
15. Secure the coupler bracket to the right side of the frame with (2) 3/8–16 x 1” lg. capscrews and locknuts as shown in figure 9. 4 2 1 3 3 5 6 Figure 10 1. Hydraulic hose–A 2. Coupler bracket 3. Retaining ring 4. Dust cap 5. Hydraulic hose–B 6. Dust plug 21. Install the fuel tank fasteners. 1 22. Install the seat base and the seat. Figure 9 1. Coupler bracket 16. Slide the loop end of the dust plug over the end of hydraulic hose from front valve fitting.