Installation Instructions

ManualsBrandsToro ManualsAttachments18in Transport Conversion Kit, Trans Pro 100

FormNo.3416-250RevA

18inTransportConversionKit

TransPro100

ModelNo.110-7355

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

Thisproductcontainsachemical

orchemicalsknowntotheStateof

Californiatocausecancer,birthdefects,

orreproductiveharm.

Theengineexhaustfromthisproduct

containschemicalsknowntotheStateof

Californiatocausecancer,birthdefects,

orotherreproductiveharm.

Note:Retainallcomponentsforreuseunless

otherwisespecied.

1.Removethefastenerssecuringthestandard

insertstotheoorandremovetheinserts

(Figure1).

g217624

Figure1

1.Trailerstop3.Wheelrod

2.Standardinsert

2.Removethefastenerssecuringthetrailerstops

andspacerstoeachsideofthetrailer(Figure1).

3.Ontrailerswithserialnumberspriorto

260000400,usethedimensionsshowninFigure

2tolocate,markanddrilla0.41inch(10.4

mm)diameterholeineachendofthestandard

inserts.Thenewholesshouldbethesame

distancefromtheendsastheexistingsquare

holesintheinsert.

Note:Iftheholesalreadyexistinthese

locations,gotothenextstep.

g217625

Figure2

1.0.41inch(10.4mm)

diameterhole

3.2.1inches(53.3mm)from

theoppositeside

2.1inch(25.4mm)fromthe

rampendofinsert

4.Usingtheholesintheinserts,mounteachtothe

oorwitheither2screws(3/8x2-1/4inch)or2

carriagebolts(dependingontheconguration

oftheinserthole),spacers,andlocknuts(Figure

3).Positionthespacersbetweentheinsertand

theoor.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3416-250*A

Summary of content (2 pages)

PAGE 1
Form No. 3416-250 Rev A 18in Transport Conversion Kit Trans Pro 100 Model No. 110-7355 Installation Instructions Note: If the holes already exist in these locations, go to the next step. WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
PAGE 2
g217626 Figure 3 1. Wheel rod 2. Side insert 3. Standard insert 5. Using the 2 rear holes in each side insert, mount an insert to each side of the trailer with 2 carriage bolts (3/8 x 2-1/4 inch), 2 spacers, and 2 locknuts. Position the spacers between the insert and the side 6. Using the front holes in the inserts, install the trailer stops and spacers with the screw and nut previously removed. Position the spacers inside the insert. 7.