Installation Instructions

Printed in the USA

W 2006 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Blower Stop Kit

Groundsmaster

)

3320/3280–D with Cab

Part No. 110–5838

Form No. 3356–399 Rev. A

Installation Instructions

1. Using the dimensions shown in figure 1, locate, mark

and drill (2) .250 inch diameter holes in the top wall of

the right hand lift arm. Both holes to be on the center

of the arm.

12.25”

1.00”

.250” dia. (2)

Figure 1

1. Right hand lift arm

2. Mount the stop assembly to the lift arm with (2) thread

forming screws. Position the stop assembly as shown

in figure 2.

Figure 2

1. Stop assembly

PAGE 1
Form No. 3356–399 Rev. A Blower Stop Kit Groundsmaster) 3320/3280–D with Cab Part No. 110–5838 Installation Instructions 1. Using the dimensions shown in figure 1, locate, mark and drill (2) .250 inch diameter holes in the top wall of the right hand lift arm. Both holes to be on the center of the arm. .250” dia. (2) 1.00” 12.25” 1 Figure 1 1. Right hand lift arm 2. Mount the stop assembly to the lift arm with (2) thread forming screws. Position the stop assembly as shown in figure 2. 1 Figure 2 1.