Installation Instructions

2
1
2
Figure 2
1. Attachment frame 2. Support tube
6. Repeat the procedure on the opposite lift arm.
7. Start the traction unit and raise the attachment frame.
8. Push down on the rear of the attachment frame and
insert the support rods through the lift arm pads.
9. Install the height of cut collars onto the support rods
and secure with the clevis pins and hair pin cotters
(Fig. 2). Head of clevis pin to be positioned toward the
front of the attachment frame.
10. Tighten the capscrews securing the support rods to the
bottom of the attachment frame tube (Fig. 2).
11. Install a 1/2 x 3/4 inch capscrew, 1/2 inch lockwasher
and a 9/16 x 1–3/8 inch flat washer to the top of each
support rod (Fig. 2).