Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 111-6800

FormNo.3395-693RevA

BladeKit

Model02601/02605HoverPro450/550Machine

ModelNo.111-6800

ModelNo.111-6801

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Upstopbracket1

Insert(M4)

Screw(M4)

Installtheupstopbracket.

Bladebolt1

Blade1

Installtheblade.

Important:ThiskitisintendedforuseonHoverPro

models02601and02605only.

InstallingtheUp-StopBracket

Partsneededforthisprocedure:

1Upstopbracket

Insert(M4)

Screw(M4)

Procedure

1.TurnthefuelswitchtotheOffposition.

2.Disconnectthewirefromthesparkplug

3.Tiltthemachineonitsleftsidetogainaccessunder

thedeck.

4.Gentlytaptheinserts(M4)intothe2holesinthedeck

asshowninFigure1.

Figure1

1.Inserts(M4)

3.Upstopbracket

2.Screws(M4)

5.Positiontheup-stopbracketonthetopofthedeckas

showninFigure1andsecureitinplacewith2screws

(M4).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUK.

AllRightsReserved

*3395-693*A

Summary of content (2 pages)

PAGE 1
Form No. 3395-693 Rev A Blade Kit Model 02601/02605 HoverPro 450/550 Machine Model No. 111-6800 Model No. 111-6801 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 Description Up stop bracket Insert (M4) Screw (M4) Blade bolt Blade Use Qty. 1 2 2 1 1 Install the up stop bracket. Install the blade. Important: This kit is intended for use on HoverPro models 02601 and 02605 only.
PAGE 2
Installing the Blade Parts needed for this procedure: 1 Blade bolt 1 Blade Procedure WARNING The blade is sharp; contacting the blade can result in serious personal injury. • Disconnect the wire from the spark plug. • Wear gloves when handling the blade. Figure 2 1. Remove the bolt, retaining bolt, and spacers to gain access to the blade carrier assembly. 2. Retain the spacers, and discard the blade carrier assembly and the bolt. 1. Blade bolt 3. Existing spacers 2. Existing retaining bolt 4.