Installation Instructions

ManualsBrandsToro ManualsRiding ProductsCutter Motor Drain Line Kit, T4240 4-Wheel Drive 5-Plex 5 Mower Traction Unit

FormNo.3394-503RevA

Cutter-MotorDrain-LineKit

forT42404-WheelDrive5-Plex5MowerTractionUnit

ModelNo.111-8082

InstallationInstructions

Thiskitreroutesthecutter-motordrain-linedirectlybacktothetanktoprepareforpotentialcuttermotorreplacements.

Beforeinstallingthiskit,refertoyourmachine’sOperator’sManualforsafetyinstructionsandtheproductoverview.

Important:Ifafterreadingtheseinstructionsyouarestillunsureofhowtoinstallthiskit,contactyourAuthorized

ToroDealerforhelp.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Blankingcap3

1/4inchto3/8inchadaptor

1/4inchcrossadaptor

3/8inchhose

Cabletie

3/8inchteeadaptor

Installthekit.

1.Lowerthecuttingunits,stoptheengine,removethe

key,andensurethatthereisnoremainingpressurein

thehydrauliccircuit.

2.Raiseandsupporttheoperator’splatform.

3.Disconnectthecenter,right,andleft1/4inch

cutter-motorhosesfromthebottomofthereturn

manifold(Figure1).

G028933

Figure1

1.1/4inchcuttermotorhoses

4.Insert3blankingcapsintotheopeningsinthereturn

manifold.

5.Connectthe1/4inchto3/8inchadaptortothe1/4

inchcrossadaptor(Figure2).

G028934

Figure2

1.New3/8inchhose4.Leftwingmotorhose

2.1/4to3/8inchadaptor5.1/4inchcrossadaptor

3.Centermotorhose

6.Rightwingmotorhose

6.Connectthenew3/8inchhosetotheadaptor(Figure

2).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUK

AllRightsReserved

*3394-503*A

Summary of content (2 pages)

PAGE 1
Form No. 3394-503 Rev A Cutter-Motor Drain-Line Kit for T4240 4-Wheel Drive 5-Plex 5 Mower Traction Unit Model No. 111-8082 Installation Instructions This kit reroutes the cutter-motor drain-line directly back to the tank to prepare for potential cutter motor replacements. Before installing this kit, refer to your machine’s Operator’s Manual for safety instructions and the product overview.
PAGE 2
7. Connect the hoses removed in step 3 to the cross adaptor as shown in Figure 2. Note: The center cutter-motor hose should be routed forward over the 2 hoses (1/2 inch) for the center motor. 8. Ensure that the left and right wing motor hoses are flush to the chassis cross member, and secure the cross adaptor and hoses to the frame using 3 cable ties (Figure 3). Note: Ensure that the lower hose is clear of the center head. G028935 1 Figure 3 1. Cable ties 9.