Installation Instructions

ManualsBrandsToro ManualsRiding ProductsEngine Cover Brace Kit, CT2120/CT2140/CT2240/LT3340 Turf Mower, or Groundsmaster 3400 4-Wheel Drive Traction Unit

Table Of Contents

.
- ? Installing the Engine Cover Brace

FormNo.3395-641RevA

EngineCoverBraceKit

CT2120/CT2140/CT2240/LT3340TurfMower,orGroundsmaster

34004-WheelDriveTractionUnit

ModelNo.111-8414

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Leftenginecoverbracket

Rightenginecoverbracket1

Shafthingebracket

Hingeshaft

Covertieplate

Coverclampingplate

Screw(M6)

Washer(1/4x3/4)

Nut(M6)

Splitpin

Washer(M8)

Hexnut(M8)

Rubberwasher14

Washer(5/16x7/8)

Coachbolt

Installtheenginecoverbrace.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUK

AllRightsReserved

*3395-641*A

Summary of content (4 pages)

PAGE 1
Form No. 3395-641 Rev A Engine Cover Brace Kit CT2120/CT2140/CT2240/LT3340 Turf Mower, or Groundsmaster® 3400 4-Wheel Drive Traction Unit Model No. 111-8414 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
Installing the Engine Cover Brace 3 5 1 Note: Always seek professional advice from your local authorised dealer if you are unsure how to install this kit. 2 1. Position the machine on a level surface, raise the cutting unit(s) and latch them into position, engage the parking brake, ensure that the traction pedal is in the Neutral position and the cutter blade is in the Off position, stop the engine, and remove the key from the switch. 4 2.
PAGE 3
1 3 4 1 2 2 g029245 Figure 2 1. Split pin g029247 Figure 4 2. Hinge shaft 1. Big head fastener nut 3. Washer (5/16 x 7/8) 2. Rubber washer 4. Hex nut (M8) 7. Tighten the 2 hinge-cover brackets, ensuring that there is approximately a 3 mm gap between the edge of the face where the hinge shaft bush is situated and the return edge on the underside of the engine cover. 1 8. Using the left and right hinge cover brackets and a jig, drill out 2, 8.
PAGE 4
1 2 2 3 4 4 5 g029249 Figure 7 1. Screw (M6) 4. Washer (1/4 x 3/4) 2. Washer (1/4 x 3/4) 5. Nut (M6) 3. Cover-plate tie 11. Remove the existing hinge-shaft brackets from the underside of the radiator bulkhead panel, and replace with the new ones provided. Note: Do not fully tighten at this point. 12. Refit the engine cover assembly to the machine without the hinge shaft.