Installation Instructions

Printed in the USA

W 2006 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Wheel Weight Kit

Greensmaster

)

3250–D

Part No. 112–0279

Form No. 3356–131 Rev A

Installation Instructions

1. Position the weight weight onto the wheel rim to

determine the location of the valve stem and mounting

fasteners.

2. Remove the two lug nuts from the studs that align with

the holes in the weight.

3. Thread a weight adapter onto each wheel stud. The

tapered end of the adapter is to fit into the rim.

4. Thread a stud into each adapter until the stud bottoms.

5. Install the weight over the studs, adapters and valve

stem. Make sure not to damage the valve stem.

6. Secure the weight to the adapters with two washers and

lock nuts. Torque the lock nuts to 85 to 100 ft–lb.

7. Re–torque the wheel lug nuts, adapters and lock nuts

every 200 hours.

8. Repeat the procedure on the opposite wheel.

Figure 1

1. Wheel weight

2. Adapter

3. Stud 4. Washer 5. Locknut