Installation Instructions

1
All Rights Reserved
W 2006 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Spark Arrestor Kit
Groundsmaster
)
7200/7210 Traction Units
Part No. 112–1688
Form No. 3355–544 Rev. A
Installation Instructions
Important When finished installing the spark arrestor, store this sheet with your traction unit Operator’s Manual for
future reference.
Loose Parts
Note: Use the chart below to identify parts for assembly.
Description Qty. Use
Spark arrestor
Screw
1
1
Installing the spark arrestor
Installing the Spark Arrestor
1. Park on level surface,disengage attachment, set the
parking brake, stop the engine, and remove the
ignition key.
2. Allow the traction unit to cool completely.
3. Raise the hood and support it with the prop rod.
4. Measure and cut 2 inches off the end of the tail pipe
(Fig. 1). Remove all burrs from the tail pipe.
2”
.75”
.141” dia.”
Figure 1
5. Locate, mark and drill a .141 inch diameter hole .75
inch from the end of the tail pipe (Fig. 1).
6. Slide the spark arrestor onto the tail pipe and align the
holes.
Figure 2
Important Do not use a hammer or other instrument
to pound the arrestor onto the exhaust outlet. Pounding on
the arrestor will damage it.
7. Secure the Spark Arrestor to the tail pipe with the
enclosed screw.
Maintaining the Spark Arrestor
Inspect the spark arrestor every 50 hours for damage, such
as holes in the screen, and for build-up on the screen. If it
is damaged, replace it with a new spark arrestor. If it is
dirty, remove it and clean the screen with a wire brush
and/or soak it in solvent. Install it as indicated in the
previous procedure.