Installation Instructions

ManualsBrandsToro ManualsRiding ProductsClutch Cable Kit, 2004 and After Heavy-Duty Workman Vehicles

Printed in the USA

W 2006 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Clutch Cable Kit

2004 and After Heavy Duty–Workman

)

Vehicles

Part No. 112–3181

Form No. 3357–913 Rev. B

Installation Instructions

Remove the Clutch Cable

1. Raise bed (if so equipped) and place safety support on

extended lift cylinder to hold up bed.

2. Position the vehicle on a level surface, stop engine,

engage the parking brake and remove key from

ignition switch.

Before servicing or making adjustments to the

machine, stop engine, set parking brake and

remove key from ignition switch. Any load

material must be removed from bed or other

attachment before working under raised bed.

Never work under a raised bed without

positioning safety support on a fully installed

cylinder rod.

Warning

3. At the rear of the machine, disconnect the old clutch

cable from the clutch lever ball joint (Fig. 1).

4. Remove the (2) capscrews securing the clutch cable

mounting bracket to the bell housing (Fig. 1). Retain

the capscrews.

Figure 1

1. Clutch lever

2. Ball joint

3. Mounting bracket

5. Remove the nut securing the clutch cable ball joint to

the clutch pedal (Fig. 2). Retain the nut.

Note: Note how the cable is routed for the new

installation.

Figure 2

1. Clutch cable ball joint 2. Clutch pedal

6. Install the new mounting bracket to the bell housing

using the (2) capscrews previously removed (Fig. 3).

Figure 3

1. Mounting bracket

2. Clutch cable

3. Ball joint

7. Route the new cable the same as the previous cable.

8. Thread the end of the new clutch cable into the ball

joint on the bell housing lever (Fig. 3).

9. Loosely install the clutch cable to the mounting

bracket (Fig. 3).

Summary of content (2 pages)

PAGE 1
Form No. 3357–913 Rev. B Clutch Cable Kit 2004 and After Heavy Duty–Workman ) Vehicles Part No. 112–3181 Installation Instructions Remove the Clutch Cable 1. Raise bed (if so equipped) and place safety support on extended lift cylinder to hold up bed. 2 2. Position the vehicle on a level surface, stop engine, engage the parking brake and remove key from ignition switch.
PAGE 2
3. Adjust the jam nuts/or ball joint until the back rear edge of the clutch pedal is 3.75” + .12” from the top of the floor plate diamond pattern, when an 4 lb. force is applied to the pedal (Fig. 6). 10. Mount the clutch cable rod end to the clutch pedal with the nut previously removed (Fig. 4). Make sure the rod end is not twisted on the ball stud and is parallel to the clutch pedal. 2 1 3 1 5 3.75 ± .12” 4 Figure 6 1. Clutch pedal Figure 4 1. Clutch cable rod end 2. Clutch pedal 3. Ball stud 4.