Installation Instructions

1
All Rights Reserved
Printed in the USA
W 2006 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Mow Manifold Block Kit
Reelmaster
)
6500–D and 6700–D Traction Units
Part No. 110–6120
Form No. 3356–584 Rev. A
Installation Instructions
Safety and Instruction Decals
Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
112-6555
Affix to Models 03806 and 03807
Use Part No. 112–6556 for Model 03808
1. Reel—height of cut
2. Reel—mow and backlap
3. Read the Operator’s
Manual.
4. Machine speed
5. Rear reels circuit controls
6. Front reels circuit controls
Important After installing the new mow manifold
block apply the new solenoid information decal over the
existing decal under seat. Make sure the mounting surface
is clean before affixing decal. See decal descriptions
above to determine which decal is appropriate for your
model traction unit.
Operation
Backlap Knobs
The backlap knobs are used in conjunction with the lower
mow/raise control lever for backlapping operation. Refer
to Backlapping section in Operator’s Manual.
Figure 1
1. Backlap knobs 2. Reel control knobs
Reel Speed Controls
Controls speed (RPM) of front and rear cutting units. #1
position is for backlapping. Remaining settings are for
mowing operations. See new decal for proper settings.