Installation Instructions

Form No. 3357-919 Rev B

Weight Kit

For 2007 and After Commercial Floating-Deck

Mid-Size Mowers

Model No. 112–9971

Installation Instructions

Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.

Loose Parts

Use the chart below to verify that all parts have been shipped.

Step

Description

Qty.

Use

No parts required

–

Use the weight for Performance.

No parts required

–

Use the Weight with a TRU TRAK®

Sulky

Weight

Bolt (5/16 x 2 inches)

Bolt (5/16 x 3 inches)

Bolt (5/16 x 4 inches)

Bolt (5/16 x 5 inches)

Locknut (5/16 inch)

Washer (5/16 inch)

Install the weight.

8111 Lyndale Avenue South

Bloomington, MN 55420

Printed in the USA.

PAGE 1
Form No. 3357-919 Rev B Weight Kit For 2007 and After Commercial Floating-Deck Mid-Size Mowers Model No. 112–9971 Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Use the chart below to verify that all parts have been shipped. Step 1 2 3 Description Qty. Use No parts required – Use the weight for Performance.
PAGE 2
Step 1 With the weights installed in the rear position, the front end of the machine can rapidly rise up when the mower is removed. This could cause serious injury to you or bystanders. Using the Weight for Performance Support the rear of the machine when removing the mower from the carrier frame. No Parts Required Step Procedure 2 • Weights are installed to improve handling, balance and improve performance.
PAGE 3
Step 3 Installing the Weight Parts needed for this step: 1 2 2 2 2 2 2 Weight Bolt (5/16 x 2 inches) Bolt (5/16 x 3 inches) Bolt (5/16 x 4 inches) Bolt (5/16 x 5 inches) Locknut (5/16 inch) Washer (5/16 inch) Figure 1 Procedure Installing the front weight. 1. Disengage the PTO, stop the engine, remove the key, and wait for all moving parts to stop before leaving the operating position. 1. 2. Bolt Washer 3. 4. Weight Nut 2. Determine the size of bolt needed to install the weights.
PAGE 4