Installation Instructions

FormNo.3359-116RevA

ReplacementDipstickKit

ModelNo.114–4138

ModelNo.115–0940

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

RemovetheExistingCap/Adapter

System

Oilllcap

O-ringseal(T oroPartNo.57–9610)

Threadformingscrew

Dipstick1

InstallNewDipstickCap

NoPartsRequired

RemoveExistingCap/AdapterSystem

1.Unscrewandremovetheoilllcapfromtheadapter

(Figure1).

2.Unscrewtheadapterfromthedipsticktube

(Figure1).

Note:MakesurethelowerO-ringisremovedfrom

theadapter/dipsticktube(Figure1).Discardall

components.

Figure1

1.Oilllcap

5.Adapter

2.Dipstick

6.O-ring

3.Screw

7.Dipsticktube

4.O-ring

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3359-116 Rev A Replacement Dipstick Kit Model No. 114–4138 Model No. 115–0940 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Remove the Existing Cap/Adapter System 2 Oil fill cap O-ring seal (Toro Part No. 57–9610) Thread forming screw Dipstick 1 1 1 1 Install New Dipstick Cap 1 No Parts Required Remove Existing Cap/Adapter System 1.
PAGE 2
Install New Dipstick Cap Parts needed for this procedure: 1 Oil fill cap 1 O-ring seal (Toro Part No. 57–9610) 1 Thread forming screw 1 Dipstick Procedure 1. Install an O-ring (Toro Part No. 57–9610) onto the new oil fill cap. Push the O-ring past the threads and into the groove above the cap’s threads (Figure 2). Figure 2 1. Oil fill cap 2. O-ring 3. Dipstick 4. Thread forming screw 5. Dipstick tube 2. Install the dipstick to the oil fill cap with the thread forming screw (Figure 2). 3.