Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 115-1015

FormNo.3359-184RevA

Trim/DischargeSideAnti-ScalpRollerKit

48inTURBOFORCE

FloatingMowerforWalk-BehindMower

ModelNo.115–1015

ModelNo.115–1016

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Rollerbracket1

Carriagebolt(3/8x3/4inch)

Flangenut(3/8inch)

Installtherollerbracket.

Anti-scalproller1

Bolt(3/8x4-1/2inches)

Longspacer1

Shortspacer

Flangenut(3/8inch)

Installtheanti-scalproller.

InstallingtheRollerBracket

Partsneededforthisprocedure:

1Rollerbracket

Carriagebolt(3/8x3/4inch)

Flangenut(3/8inch)

Procedure

1.Preparetheinstallationsiteasfollows:

•Ifyouarereplacinganexistinganti-scalproller,

removetheroller,rollerbracket,andallfasteners

fromthemoweranddiscardthem.

•Ifyouareinstallingtheanti-scalprollerforthe

rsttime,locatethethreeholesonthereartrim

ordischargesideofthemower(dependingon

whichkityouareinstalling)andremovethethree

boltsandnutsthatareinstalledintheholes.

2.Installtherollerbrackettothemowerusing3

carriagebolts(3/8x3/4inch)andangenuts(3/8

inch)(Figure1).

Important:Ensurethatyouinstallthecarriage

boltswiththeboltheadsontheinsideofthe

mowerdeckandthenutsontheoutside.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (2 pages)

PAGE 1
Form No. 3359-184 Rev A Trim/Discharge Side Anti-Scalp Roller Kit 48in TURBO FORCE® Floating Mower for Walk-Behind Mower Model No. 115–1015 Model No. 115–1016 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 Description Roller bracket Carriage bolt (3/8 x 3/4 inch) Flange nut (3/8 inch) Anti-scalp roller Bolt (3/8 x 4-1/2 inches) Long spacer Short spacer Flange nut (3/8 inch) Qty.
PAGE 2
Note: Insert the bolt so that its head is toward the outside of the mower. 4. Secure the roller with a flange nut (3/8 inch) (Figure 1). Figure 1 1. Roller bracket 2. Carriage bolt (3/8 x 3/4 inch) 3. Flange nut (3/8 inch) 4. Anti-scalp roller 5. Bolt (3/8 x 4-1/2 inches) 6. Short spacer 7. Long spacer 2 Installing the Anti-Scalp Roller Parts needed for this procedure: 1 Anti-scalp roller 1 Bolt (3/8 x 4-1/2 inches) 1 Long spacer 1 Short spacer 1 Flange nut (3/8 inch) Procedure 1.