Installation Instructions

ManualsBrandsToro ManualsAttachmentsFront Brush Kit for Wide Wiehle Roller, 21in DPA Greensmaster Cutting Reel

FormNo.3431-241RevB

FrontBrushKitforNarrowandWideWiehleRollers

andFullRollers

DPAGreensmaster

CuttingUnits

ModelNo.115-7377

ModelNo.115-7378

ModelNo.115-7379

ModelNo.120-9621

ModelNo.120-9622

ModelNo.120-9623

ModelNo.139-4383

ModelNo.139-5117

ModelNo.139-5125

ModelNo.139-7410

ModelNo.139-7412

InstallationInstructions

Installation

PreparingtheMachine

NoPartsRequired

Procedure

RefertoyourcuttingunitOperator’sManualfor

instructionstopreparethemachineandcuttingunit

forinstallation.

InstallingtheBrush

Partsneededforthisprocedure:

1Brush

Screw

Capscrew

Clamp

Procedure

1.Removetheplowbolt,washerandnutsecuring

oneoftheheightofcut(HOC)armstothe

cuttingunitsideplate(Figure1).

2.LoosentherollermountingscrewsintheHOC

arms(Figure1).

3.SlidetheHOCarmofftherollershaft(Figure1).

4.SlidetherollershaftoutoftheHOCarmonthe

oppositeendofthecuttingunit.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3431-241*B

Summary of content (2 pages)

PAGE 1
Form No. 3431-241 Rev B Front Brush Kit for Narrow and Wide Wiehle Rollers and Full Rollers DPA Greensmaster® Cutting Units Model No. 115-7377 Model No. 115-7378 Model No. 115-7379 Model No. 120-9621 Model No. 120-9622 Model No. 120-9623 Model No. 139-4383 Model No. 139-5117 Model No. 139-5125 Model No. 139-7410 Model No.
PAGE 2
g016701 Figure 1 1. Adjusting screw 4. Washer 2. HOC arm 3. Plow bolt 5. Nut 6. Roller mounting screw 5. Loosely install a capscrew and nut onto each clamp (Figure 2). Do not tighten. 6. Insert a shaft clamp onto each end of the roller shaft (Figure 2). 7. Loosely install the roller to the cutting unit with the HOC arm and fasteners previously removed. 8. Adjust to the desired height of cut and tighten HOC arm mounting fasteners. 9.