Installation Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 117-0061

1 of 2 769-06050

April 08, 2010

46” Snow Blade Extension Kit

ITEM

NO.

PART

NUMBER

QTY DESCRIPTION

1 112-0557 12 3/8-16 x 1.25” GR5 HHCS

2 112-0668 10 3/8-16 Nylon Flange Lock Nut

2 Bracket: Snow Blade Extension

1 Brace: Snow Blade Extension

1 THIS INSTRUCTION SHEET

OEM-190-833

190-833-000

117-0061

PURPOSE: This service kit provides the necessary hardware and installation instructions to assure proper

operation of the 46” OEM-190-833 Snow Blade when installing on some Model Year 2010 and newer TORO Garden Tractors.

NOTE: This Service Kit is needed on tractors with the 16” front tires and 23” rear tires.

Models

Affected:

Subject:

Date:

Service Kit

NOTE: These materials are prepared for use by trained technicians who are experienced in the service and repair

of equipment of the kind described in this publication, and are not intended for use by untrained or inexperienced

individuals. Such individuals should seek the assistance of an authorized service technician or dealer.

NOTE: Save this Instruction Sheet. Refer to it when ordering replacement parts.

Service Kit Contents

See Figure 1

Installation Instructions:

NOTE: These instructions were written as if the

OEM-190-833 Snow Blade has already been

assembled, installed on the tractor and found not to be

lowering all the way to the ground.

1. Park the tractor on a flat and level surface. Remove

the ignition key and set the parking brake ON.

2. Remove the negative battery cable from the negative

battery terminal.

3. Remove the 46” snow blade assembly from the

tractor. Refer to the OEM-190-833 46” Snow Blade

Operator’s Manual for removal.

4. Remove the pivot support bracket from the upper

and lower angle braces. Retain the pivot support

bracket. Discard the mounting hardware.

Form No. 3365-427 Rev A

Read through and understand these instructions completely before proceeding with installation.

FIGURE 1

112-0557

112-0668

5. Remove the lower angle brace from the front of the

right and left hand hitch brackets. Discard the lower

angle brace and mounting hardware.

Angle Brace

Pivot Support Bracket

Lower Angle Brace

FIGURE 2

Upper

Discard

* - Not Available Separately

Summary of content (2 pages)

PAGE 1
Form No. 3365-427 Rev A Service Kit 117-0061 Date: April 08, 2010 Subject: 46” Snow Blade Extension Kit Models OEM-190-833 Affected: 190-833-000 Read through and understand these instructions completely before proceeding with installation. PURPOSE: This service kit provides the necessary hardware and installation instructions to assure proper operation of the 46” OEM-190-833 Snow Blade when installing on some Model Year 2010 and newer TORO Garden Tractors.
PAGE 2
6. Install the snow blade extension brace, Ref.# 4 in Figure 1, on the back side of the right and left hand hitch brackets with the short leg of the brace towards the tractor. See Figure 3. RH Hitch Bracket LH Hitch Bracket New Snow Blade Extension Brace Pivot Support Bracket FIGURE 3 7. Secure the snow blade extension brace to the right and left hitch brackets with two (2) of the Ref.# 1 (1120557) 3/8-16 x 1.25” HHCS and two (2) of the Ref.# 2 (112-0668) 3/8-16 nylon flange lock nuts.