Installation Instructions

FormNo.3373-399RevA

TrashBagKit

GrandStand

MowerandZMaster

RidingMower

ModelNo.117-0448

InstallationInstructions

Installthiskitoneithersideofthemachine.Installingiton

theleftsideallowsforinstallationoftheChuteGateKiton

therightside.Installingtwokits,oneontheleftside,andone

ontherightsideisoptional.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Bracket1

Bolt(3/8x1inch)(Selftapping)

InstallthebrackettoaGrandStand

Mower.

Bracket1

Bolt(3/8x1inch)

InstallthebrackettoaZMasterMower.

Trashbag1Installthetrashbag.

InstallingtheBrackettoa

Grandstand

Mower

Partsneededforthisprocedure:

1Bracket

Bolt(3/8x1inch)(Selftapping)

Procedure

Installthebrackettothesideofthemachinewith2bolts

(3/8x1inch)(Figure1).

Note:Theboltsarethreadformingbolts.Theholesdonot

requiretapping.

Figure1

1.Leftsideofmachine3.Bolt(3/8x1inch)

2.Bracket

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3373-399 Rev A Trash Bag Kit GrandStand® Mower and Z Master® Riding Mower Model No. 117-0448 Installation Instructions Install this kit on either side of the machine. Installing it on the left side allows for installation of the Chute Gate Kit on the right side. Installing two kits, one on the left side, and one on the right side is optional. Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 Description Use Qty.
PAGE 2
3 Installing the Bracket to a Z Master® Mower Installing the Trash Bag Parts needed for this procedure: Parts needed for this procedure: 1 Bracket 2 Bolt (3/8 x 1 inch) 1 Trash bag Procedure Install the trash bag into the slots in the handle assembly (Figure 3). Procedure Installing this kit on the left side allows you to install the Chute Gate Kit on the right side. Install the bracket to the side of the machine with 2 bolts (3/8 x 1 inch) (Figure 2). Figure 3 1. Trash bag Figure 2 1.