Installation Instructions

ManualsBrandsToro ManualsRiding ProductsHydraulic Hose Kit, Cutting Units for Greensmaster 3150 Traction Unit

FormNo.3438-821RevA

HydraulicHoseKit

CuttingUnitsforGreensmaster

3150TractionUnit

ModelNo.117-2725

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Hydraulichoseassembly(105-5400)

Hydraulichoseassembly(105-5401)

Hydraulichoseassembly(105-5402)

Hydraulichoseassembly(95-2908)

Hydraulichoseassembly(105-5404)

Hydraulichoseassembly(106-9674)

Hydraulichoseassembly(105-5405)

O-ring[ORFS-8]

O-ring[ORFS-10]

O-ring[ORFS-4]

O-ring[ORFS-6]

Installthekit.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Lowerthecuttingunits.

4.Shutofftheengineandremovethekey.

InstallingtheKit

WARNING

Hydraulicuidescapingunderpressurecan

penetrateskinandcauseinjury.

•Ensurethatallhydraulicuidhoses

andlinesareingoodconditionandall

hydraulicconnectionsandttingsaretight

beforeapplyingpressuretothehydraulic

system.

•Keepyourbodyandhandsawayfrom

pinholeleaksornozzlesthatejecthigh

pressurehydraulicuid.

•Usecardboardorpapertondhydraulic

leaks.

•Safelyrelieveallpressureinthehydraulic

systembeforeperforminganyworkonthe

hydraulicsystem.

•Getimmediatemedicalhelpifuidis

injectedintoskin.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3438-821*A

Summary of content (2 pages)

PAGE 1
Form No. 3438-821 Rev A Hydraulic Hose Kit Cutting Units for Greensmaster® 3150 Traction Unit Model No. 117-2725 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine.
PAGE 2
1. Important: Before installing any hydraulic Locate and remove the hoses to be replaced as shown in Figure 1. hoses, make sure the correct O-rings are in position and lubricated with hydraulic fluid. Note: When removing the old hoses, remember how they were routed through the components in the machine. 2. Replace the old hoses and O-rings with the appropriate new ones. The part number of each new hose is shown in Figure 1. g316874 Figure 1 1. Left reel motor 2. Center reel motor 3.